Signify LLC7470 RF Mesh Node

Specifications
| Dimensions | 95.0 mm (3.74 in) height, 19.5 mm (0.77 in) connector length |
|---|---|
| Weight | 0.245 kg |
| IP Rating | IP66 |
| Voltage | 120-240 V, 50/60 Hz |
| Temperature Range | -30°C to +25°C |

Weight Distribution

Installation Steps



- Must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
- Make sure power is OFF
- Note
There shall be an external fuse or MCB in the Line connection with a current rating of 16A or less. - Note
RF node can only be used in overvoltage category II environment classified as IT equipment.
Compliance
Hereby, Signify declares that the radio equipment type LLC7470 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following Internet address: www.signify.com/red
Warning Do not use any chemical cleaning agents on the LLC7470.
© 2021-2025 Signify Holding. All rights reserved. The information provided herein is subject to change, without notice. Signify does not give any representation or warranty as to the accuracy or completeness of the information included herein and shall not be liable for any action in reliance thereon. The information presented in this document is not intended as any commercial offer and does not form part of any quotation or contract, unless otherwise agreed by Signify. All trademarks are owned by Signify Holding or their respective owners.
UK importer address:
Signify Commercial UK Limited 2 Guildford Business Park GU2 8XG, UK www.signify.com/products
Frequently Asked Questions
Can the LLC7470 be used in all environments?
What should I do before starting the installation?
Are there any specific wiring instructions for connecting the Driver Mains?
Documents / Resources
![]() | LLC7470 RF Mesh Node |
References
- signify.com/productswww.signify.com
- signify.com/redwww.signify.com
- User Manualmanual.tools

