GUNNER Dog Bed

Specifications
- No tools needed for assembly
- Waterproof material for easy cleaning
- 3D Loop Bolster insert
FEATURES
- The cover material is a heavy-duty performance fabric that combats whatever life throws your way. It’s tested for abrasion up to 15,000 cycles, so rest easy it won’t let you down.
- We kept sustainability top of mind when selecting a cover material; performance fibers woven into ours are made of 34% recycled plastic bottles.
- The bed itself is made of a proprietary material that holds up to daily life: it’s waterproof, breathable, fire retardant, and mold/mildew resistant with proper care.
- GUNNER specifically chose the 2.7lb density of the bed for ultimate comfort, no matter if your dog weighs 6 or 106 lbs.
- The zipper is weather-resistant and sturdy to last the lifetime of your bed.
- Easy carry handles make moving your bed around a breeze, grab and go.
- The bottom of the bed cover is non-slip, waterproof, and tear-resistant. The Homestead Dog Bed won’t go sliding across wood floors or soak up water from a spill or wet surface.
We know you’re handy with power tools, but save those for another day – the Homestead Dog Bed is ready to roll right out of the box. What follows is a breakdown on how to disassemble your bed for cleaning and upkeep.
TOOLS NEEDED
No tools needed for assembly.
cleaning & disassembly guide
- Start by fully unzipping the bolster (side) zipper.
Next, pull the bolster insert out of the cover sleeve.
- Remove the bolster insert completely from the cover sleeve, set aside and turn the bed over.

- Once the bed is flipped over, open the velcro flap and pull the double zipper open.

- Starting with one corner, reach in and remove the bed base from the bed cover.

- Set the base insert aside with the bolster insert. Wash the cover on gentle cycle and let air dry or tumble dry on low heat. The bed and bolster inserts* are completely washable thanks to the proprietary waterproof material. Spray down with a hose or submerge in the bathtub (add soap if needed) to clean – make sure to rinse well. Shake it off and let air dry.
- GOT A SPILL?
- No problem – the cover material is easy to spot clean.
If the mess requires a full wash, we’ve got you covered there too. Remove the outer cover, zip up the zippers and toss in the washer. Tumble dry on low heat or air dry to avoid shrinkage. - To wash the 3D Loop Bolster insert, remove the bolster bag.
- After washing, place the base insert back into the cover. Starting with one corner, pulling up on the cover opening, slide in the insert. The flexible loop material should bend and snap back into place inside the cover. Zip the cover back up once the insert is secured.

- Flip the bed over and take one of the open ends of the bolster insert. Slide it into the cover sleeve. Pull the bolster insert all the way through the cover sleeve until it meets up with the other open edge.

- Next, pull the edges of the cover over the bolster insert. Fully close the bolster zipper around the bed.

FAQs
Can I use bleach to clean the bed?
Avoid using bleach as it may damage the waterproof material. Stick to gentle cleaning methods like using mild soap.
How often should I wash the bed?
It is recommended to wash the bed cover regularly, especially if your pet has frequent accidents or sheds a lot of fur.
Can I put the bed in the dryer?
Yes, you can tumble dry the cover on low heat. Ensure it is fully dry before reassembling the bed.
Documents / Resources
![]() | Dog Bed |
References
- User Manualmanual.tools
Published: September 23, 2025

