45Homelab HL15 Storage Server Review Installation Guide

HL15 Storage Server Review

Product Information

Specifications:

  • Components:
    1. Fan wires
    2. Mini-SAS cables
    3. Power switch cable
  • Compatibility: Chassis to motherboard or
    controller

Product Usage Instructions

Connecting Internal Cables:

This section guides you on correctly connecting the internal
cables from the chassis to your motherboard or controller.

Fan Wires:

Note: Ensure there is space for reset switch,
HDD LED, and power LED if in use.

Only for Buyers without PSU:

Connect the midplane to the power supply unit using a 4-pin
female Molex to midplane cable. If using a Corsair PSU, contact us
at info@45homelab.com for the appropriate cable.

Frequently Asked Questions (FAQ)

Q: What should I do if I need additional cables for a Corsair
PSU?

A: For additional cables compatible with Corsair PSUs, please
contact us at info@45homelab.com.

“`

This section helps you correctly connect the internal cables shown in the chassis to your motherboard or controller. The components visible include:
a. Fan wires b. Power switch cable c. Mini-SAS cables

a. Fan wires

b. Mini-SAS cables

c. Power Swich cables 1. Fan Wires:
Connect the fan cable extender coming from fan hub port to motherboard: · Use SYS_FAN, CHA_FAN, or FAN1, FAN2, etc., as labeled on your motherboard.
2. Power Switch Cable: · Plug this into the motherboard Front Panel Header: · Look for labels like F_PANEL, PANEL1, or similar. · Connect to the PWR SW pins (polarity does not matter for switch). · Most often located at the bottom-right of the motherboard.

Note: Make sure to leave space for reset switch, HDD LED, and power LED if those are also in use.
3. Mini-SAS (SFF-8087) Cables: Connect the Mini-SAS cables to one of the following, depending on your system setup: · A RAID controller card · An HBA (Host Bus Adapter) card · A motherboard with integrated Mini-SAS ports
** Only for buyers who purchased the chassis and backplane (without PSU):
Connect the midplane to the power supply unit using a 4-pin female Molex to midplane cable. (Note: If you’re using a Corsair PSU, you can order the appropriate cable by contacting us at info@45homelab.com.)

Documents / Resources

45Homelab HL15 Storage Server Review [pdf] Installation Guide
HL15 Storage Server Review, HL15, Storage Server Review, Server Review

References

Leave a comment

Your email address will not be published. Required fields are marked *