cometo-LOGO

cometo CK100HPY-A1 360 Photo Booth Machinecometo-CK100HPY-A1-360-Photo-Booth-Machine-PRODUCT 注意

  1. 使用前请检查电源线、底座灯条线等是否卡在转台上,以免损坏线缆。
  2. 为了用户的安全,不要在S上用力跳tage.
  3.  不要做S的边缘tage bear too much weight, better distribute e weight evenly on the stage.
  4. 在Stage 使用前应通过旋转脚杯将其调整为与地面平行。
  5. 旋转杆在运行时不要故意停止。
  6. 请勿在角度调节器和自拍伸缩杆上放置重物。
  7. Children should not use it alone but must be accompanied by an adult

组件介绍

收到的附件以cometo-CK100HPY-A1-360-Photo-Booth-Machine-FIG-1

cometo-CK100HPY-A1-360-Photo-Booth-Machine-FIG-2

  • Step1: Take the Stag从包装中取出并使用脚杯将其调整为与地面平行。 然后将 AC-DC 适配器连接到控制箱。cometo-CK100HPY-A1-360-Photo-Booth-Machine-FIG-3
  • Step2: Install the Selfie Telescopic Rod, and lock it with Fixed Screw.cometo-CK100HPY-A1-360-Photo-Booth-Machine-FIG-4
  • Step3: Install the Selfie Telescopic Rod, and lock it with Fixed Screw.cometo-CK100HPY-A1-360-Photo-Booth-Machine-FIG-5
  • Step4: Stick the LED Strip to the base and connect it to 5V Adapter (for LED Strip).cometo-CK100HPY-A1-360-Photo-Booth-Machine-FIG-6
  • Step5: Install Ring Light.cometo-CK100HPY-A1-360-Photo-Booth-Machine-FIG-7
  • Step6: Install Fixed Bracket and Phone Holderscometo-CK100HPY-A1-360-Photo-Booth-Machine-FIG-8
  • Step7: Install the 4 Trolley Wheels on the Trolley with M6 Screws (Optional Matching).cometo-CK100HPY-A1-360-Photo-Booth-Machine-FIG-9
  • Step8: LED light、power pack、lithium battery connection and use (LED light power pack and Lithium batteries are not our standard accessories). Paste the LED light bar on the edge of the turntable and tie it with a tie. The motor controller shall be connected to the port of the 24 V power supply. The LED light has a port that connects to the 12 V adapter power supply.cometo-CK100HPY-A1-360-Photo-Booth-Machine-FIG-10
  • Step9: 13″ LED RING FILL LIGHT Multiple color temperature

操作说明

Install suitable batteries for all remote controls(CR-2032). Power up the AC-DC adapter. Plug the two USBs (Ring Light& LED Strip) into the power bank and 5V adapter. FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditio ns: (1) this device may not cause harmful interference, and (2) this device must accept any interfere nce received,including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

注意: 本设备经测试证明符合FCC规则第15部分中关于B类数字设备的限制。 这些限制旨在为住宅安装中的有害干扰提供合理的保护。 本设备会产生使用并辐射射频能量,如果未按照说明进行安装和使用,可能会对无线电通信造成有害干扰。 但是,不能保证在特定安装中不会发生干扰。 如果此设备确实对无线电或电视接收造成有害干扰(可以通过打开和关闭设备来确定),则鼓励用户尝试通过以下一种或多种措施来纠正干扰:

  • 重新调整或摆放接收天线。
  • 增加设备和接收器之间的距离。
  • 将设备连接到与接收器不同电路的插座上。
  • 向经销商或经验丰富的无线电/电视技术人员咨询重要公告

辐射暴露声明
To comply with FCC RF exposure compliance requirements, this grant is applicable to only mobile configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter

文件/资源

cometo CK100HPY-A1 360 Photo Booth Machine [pdf] 用户手册
CKHPY, 2A76X-CKHPY, 2A76XCKHPY, CK100HPY-A1, 360 Photo Booth Machine, CK100HPY-A1 360 Photo Booth Machine

发表评论

您的电子邮件地址将不会被公开。