Redmi 9C Manual - Download [optimized]Redmi 9C Manual - Download
Thank you for choosing Redmi 9C
Long press the power button to turn on the device.
Follow the on-screen instructions to conﬁgure the device.
For more information, visit our oﬃcial website:
Redmi 9C comes pre-installed with MIUI, our customized Android-based OS which provides frequent updates and user-friendly features based on suggestions from over 200 million active users worldwide. For more information, please visit en.miui.com
WARNING: Do not disassemble this device.
Special precautions must be taken to safely dispose of this product. This marking indicates that this product may not be discarded with other household waste in the EU. To prevent harm to the environment or human health from inappropriate waste disposal, and to promote the sustainable reuse of material resources, please recycle responsibly.
To safely recycle your device, please use return and collection systems or contact the retailer where the device was originally purchased.
To view our Environmental Declaration, please refer to the following link: www.mi.com/en/about/environment
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO INSTRUCTIONS.
To prevent possible hearing damage, do not listen at high volume levels for long periods.
Additional safety information and precautions can be accessed at the following link: www.mi.com/en/certiﬁcation
Read all safety information below before using your device:
Please update your phone’s operating system using the built-in software update feature, or visit any of our authorized service outlets. Updating software through other means may damage the device or result in data loss, security issues, and other risks.
RED Declaration of Conformity
Xiaomi Communications Co., Ltd. hereby declares that this GSM / GPRS / EDGE / UMTS / LTE Digital Mobile Phone with Bluetooth and Wi-Fi M2006C3MG is in compliance with the essential requirements and other relevant provisions of the RE Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.mi.com/en/certiﬁcation
RF Exposure Information (SAR)
This device is in compliance with Speciﬁc Absorption Rate (SAR) limits for general population/uncontrolled exposure (Localized 10-gram SAR for head and trunk, limit: 2.0W/kg) speciﬁed in Council Recommendation 1999/519/EC, ICNIRP Guidelines, and RED (Directive 2014/53/EU).
During SAR testing, this device was set to transmit at its highest certiﬁed power level in all tested frequency bands and placed in positions that simulate RF exposure during use against the head with no separation and near the body with a separation of 5 mm.
SAR compliance for body operation is based on a separation distance of 5 mm between the unit and the human body. This device should be carried at least 5 mm away from the body to ensure RF exposure level is compliant or lower than the reported level. When attaching the device near the body, a belt clip or holster should be used which does not contain metallic components and allows a separation of at least 5 mm to be maintained between the device and the body. RF exposure compliance was not tested or certiﬁed with any accessory containing metal worn on the body, and use of such an accessory should be avoided.
Certiﬁcation Information (Highest SAR)
SAR 10 g limit: 2.0 W/Kg,
SAR Value: Head: 0.355 W/Kg, Body: 0.779 W/Kg (5 mm distance).
This device may be operated in all member states of the EU.
Observe national and local regulations where the device is used.
The usability of this device may be restricted depending on the network provider.
Receiver Category 2
Ensure the power adapter used meets the requirements of Clause 6.4.5 in IEC/EN 62368-1 and has been tested and approved according to national or local standards.
This mobile phone oﬀers the following frequency bands in EU areas only and maximum radio-frequency power:
This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment oﬀ and on, the user is encouraged to try to correct the interference by one or more of the following measures:
RF Exposure Information (SAR)
This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy. The exposure standard for wireless devices employs a unit of measurement known as Speciﬁc Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/Kg. For body-worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an accessory that contains no metal and positions the device a minimum of 1.0 cm from the body. RF exposure compliance with any body-worn accessory that contains metal was not tested and certiﬁed, and use of such body-worn accessory should be avoided. Any accessory used with this device for body-worn operation must keep the device a minimum of 1.0 cm away from the body.
Changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device has an electronic label for certiﬁcation information.
To access it, please go to Settings > About phone > Certiﬁcation or open Settings and type “Certiﬁcation” into the search bar.
2006 indicates that this product will be launched after 202006.
Manufacturer (1): Jiangsu Chenyang Electron Co., Ltd.
address (1): No.58 Chenyang Road,Hexi Industrial Park,Huangtang
Town,212364 Danyang City, Jiangsu Province, PEOPLE’S REPUBLIC OF CHINA Manufacturer (2): Jiangxi Jian Aohai Technology Co.,Ltd.
address (2): Xietian, Quanjiang Town, Sichuan, Jian City, Jiangxi, P. R.China, 343900
This user guide is published by Xiaomi or its local aﬃliated company. Improvements and changes to this user guide necessitated by typographical errors, inaccuracies of current information, or improvements to programs and/or equipment, may be made by Xiaomi at any time and without notice. Such changes will, however, be incorporated into new online editions of the user guide (please see details at www.mi.com/global/service/userguide). All illustrations are for illustration purposes only and may not accurately depict the actual device.
|Xiaomi Redmi 9C Midnight Gray 64GB + 3GB Smart Phone [pdf] User Guide|
9C Midnight Gray 64GB 3GB Smart Phone
HL A11 UK Built-Under Larder Fridge EN SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVED…
216695 Frisco Circular Gravity Waterer Instruction Manual Frisco Circular Gravity Waterer Note: Hand wash before…
US2000C Lithium Series 48V 2.4 kWh Battery Instruction Manual Lithium Series 48V 2.4 kWh Battery…