MEEC IZIXHOBO 018722 iTread Repair Kit Instruction Manual

IMIYALELO YOKHUSELEKO

Wear safety glasses when drilling – risk of eye damage

IIMPAWU

Funda imiyalelo.
Ivunywe ngokungqinelana nemigaqo efanelekileyo.
Nxiba iiglasi zokhuseleko.
Recycled imveliso elahliweyo ngokuhambelana nemigaqo yendawo.

IINKCUKACHA ZEZIKHONO

Faka imisonto                                              Ubude.

018722 M6 x 1.0                                           6.3 mm
018723 M8 x 1.25                                         8.3 mm
018724 M10 x 1.5                                         10.4 mm
018725 M12 x 1.75                                       12.4 mm

INKCAZELO

Complete thread repair kit with taps, installation tool and inserts.
Tool and drill made of HSS steel. The inserts are made of stainless steel 304. Supplied in sheet metal box.

  1. Ikhola yokuhlengahlengisa ubunzulu
  2. Isixhobo sokufaka
  3.  Hlalutya
  4. Thepha
  5. Ukufakwa kwemisonto
   IKHIWANE. 1

USE IMPORTANT:

After drilling or threading operations all metal shavings must be carefully removed with compressed air or a magnet.

  1. Drill out the damaged thread or screw with the spiral drill (3).
  2. Cut new thread in the drilled hole with the tap. Use a suitable cutting fluid for best results.
  3. Put the thread insert on the installation tool. The driving tap on the thread insert must be put in the tap groove on the installation tool. Adjust the depth stop ring. Fit the thread insert in the newly cut thread and screw it carefully in place. 4. Snap off the installation tap with pliers.

    PHAWULA:

    Depending on the application a magnet may be need to remove the snapped installation tap. For larger sizes of thread, especially spark plug thread, the installation tap should be
    snapped and removed with snipe nose pliers.

    PHAWULA:

    Sebenzisa ulwelo lokusika olufanelekileyo kwaye ujije umva isiqingatha sempompo sejiko ngokujika ngakunye okupheleleyo ngasekunene ukuqinisekisa ukuba umsonto uyasebenza.
    – For blind holes, set the position for the depth adjustment collar (1) on the installation tool (2) so that the tap does not seat and stick out over the upper surface of the thread hole. Make sure that the thread insert tang (A) comes in the slot in the installation tool (2). FIG. 2

  4. Twist the insert in the hole to the requisite depth and remove the installation tool (2).
  5. Sebenzisa i-punch efanelekileyo kunye nehamile ukususa i-tang.

UKUGCINWA KONYANGO

Wipe the tools and thread inserts after use to clean them from
oil, dirt and shavings. Do not wash with degreaser.

UKUBHALA

Gcina iindawo kwibhokisi yentsimbi.

 

Funda ngakumbi ngale Manuwali kwaye ukhuphele iPDF:

Amaxwebhu / Izibonelelo

MEEC IZIXHOBO 018722 Thread Repair Kit [pdf] Incwadi yomyalelo
018722, 018723, 018724, Thread Repair Kit, Repair Kit, 018722, Thread Repair

Ushiye uluvo

Idilesi yakho ye email aziyi kupapashwa. amasimi ezifunekayo ziphawulwa *