Gaming Headsets for Xbox, PlayStation, PC, and Mobile | LucidSound
User Guide for LucidSound models including: LS50X Wireless Gaming Headset with Bluetooth, LS50X Wireless Gaming Headset, LS50X, Wireless Gaming Headset with Bluetooth, Wireless Gaming Headset, LS50X Gaming Headset, Headset
PowerA LucidSound LS50X Draadloze Hybrid Gaming Headset - Xbox One - Zwart | bol.com
File Info : application/pdf, 5 Pages, 319.97KB
DocumentDocumentWIRELESS GAMING HEADSET WITH BLUETOOTH USER GUIDE SETUP 1 2 IMPORTANT ! XBOX ONE FAQ 3 To complete setup for Xbox One and enable surround sound go to: http://bit.ly/30IQUMj The LS50 headset has two modes for volume control: Gaming Control Mode Left volume wheel controls the level of the incoming audio from the dongle (connected to your Xbox One). Bluetooth Control Mode Left volume wheel controls the volume level of the audiocoming from your Bluetooth device. http://bit.ly/2ZpBuzK To switch between the two control modes, press and hold the left earcup button for 1 second. HEADSET [L] Bluetooth LED Solid = Connected Slow Blink = Not Connected Double Blink = Pairing mode Power/Charging LED Solid = ON/Connected/Charged Slow Blink = Not Connected Pulsing = Charging Center Button Press and hold for 1 second to toggle between Bluetooth and Gaming modes Double click to check battery level Audio mute in Gaming mode Play/Pause/Answer/Hangup in Bluetooth mode Volume Wheel Power Button USB Charging Port Mobile 3.5mm Port Microphone Port HEADSET [R] Mic Monitoring Mic Monitor On/Off = Press and hold for 3 seconds Mic Mute Mute/Unmute = Short Press LED on Boom Mic illuminates when muted EQ/Bluetooth button Press and release to cycle through EQs Press and hold for 1 second to activate Bluetooth voice assistant Press and hold for 4 seconds for Bluetooth pairing Game / Chat Balance Bluetooth Track forward / Track back ACCESSORIES 1 Boom Mic 2 USB Base Station MICROPHONE 5V 3 USB Charging Cable 4 3.5mm Cable IN MIC 5 Mic Port Cover 6 Travel Case MIC IN 5V CHARGING Pulsing = Charging Solid = Charged MOBILE SETUP Press and hold the EQ/BT button for 4 seconds to enter pairing mode Search for Bluetooth devices on mobile phone and choose "LucidSound LS50" SUPPORT ?#!* Dongle Model No: Headset Model No: LS50XTX LS50RX FCC ID: 2AGZW06430 FCC ID: 2AGZW03595 IC ID: 21203-06430 IC ID: 21203-03595 RF Frequency: 2.40335 GHz to 2.47935 GHz Output Power: TX = 5.83 dBm RX = 3.58 dBm Manufacturer: LucidSound, Inc. Importer: Information can be found at lucidsound.com FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This device complies with FCC SAR exposure limits set forth for an uncontrolled environment The equipment can be used in close proximity to the human body without any restrictions. Caution! The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate the equipment. This device complies with FCC exposure limits set forth for an uncontrolled environment Industry Canada Statement This device complies with Industry Canada licence-exempt RSS standard. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. IC Radiation Exposure Statement: This equipment complies with IC RSS-102 radiation exposure limit set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0.5 cm between the radiator and your body. Cet équipement est conforme aux CNR-102 d'Industrie Canada. Cet équipement doit êtreinstallé et utilisé avec une distance minimale de 0.5 centimètres entre le radiateur et votrecorps. Cet émetteur ne doit pas être co-localisées ou opérant en conjonction avec autreantenne ou émetteur. Les antennes utilisées pour cet émetteur doivent être installés etfournir une distance de séparation d'au moins 0.5 centimètre de toute personne et doit pas être co-située ni fonctionner en conjonction avec une autre antenne ou émetteur. IC Radiation Exposure Statement: This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0 cm between the radiator and your body. Warranty LucidSound, Inc. warrants this product to be free from defects in materials and workmanship for the warranty period. This non-transferable, 1-year limited warranty is only to you, the first end-user purchaser. If a defect covered by this warranty occurs AND you provide proof of purchase, LucidSound, Inc., at its option, will repair or replace the product at no charge (excluding shipping). The LucidSound, Inc., 1-year limited warranty is available to customers worldwide. Your sole and exclusive remedy is repair or replacement of your LucidSound product. In no event shall LucidSound's liability exceed the original purchase price of the product. This warranty does not apply to: (a) normal wear and tear or abusive use; (b) industrial, professional or commercial use; (c) if the product has been tampered with or modified. This non-transferable warranty is only valid in the region/country in which the headset was originally purchased. To receive warranty service, please contact us at: lucidsound.com (toll free) 888-661-4469 1-760-579-6969 ©2019 Lucid Sound, Inc. 5939 Darwin Ct., Suite 100, Carlsbad, CA 92008 U.S.A. Microsoft, Xbox, Xbox "Sphere" Design, Xbox One, and Windows are trademarks of the Microsoft group of companies. All other trademarks are the property of their respective owners. The shape and design of this product are a trade dress of Lucid Sound, Inc., its subsidiaries and affiliates. All rights reserved. All other product names and images are trademarks or registered trademarks of their respective owners. Made in China. Product features, appearance and specifications may be subject to change without notice. Please retain this information for future reference.