Woods 50007 Indoor 24-Hour Digital Timer 2-C

Instructions

Charge the Battery

Plug the timer Into the wall outlet for l O minutes to charge the Internal battery.

Note: You can then unplug the timer from the wall outlet and comfortably hold It In your hand to program the timer.

Clear the Memory

• Press the R button with of toothpick to erase any previous settings.

To Set the Current Time

Press and hold the SET button for 2 seconds. The hour will begin to flash, press the+ or – button to adjust the hour up or down. To change from AM to PM press the+ or – button 12 limes. Press the SET button again to advance to the minute seffing. The minutes will begin to flash, press the+ or – button to odjust the minutes up or down. Press the PROO button to exit setting time of day.

To Program the Timer

1. Press the PROO button once to display the first setting
2. Press the SET button once to enter the hour setting mode.
3. The hour will begin to flash, press the + or – button to adjust the hour up or down.
4. Press the SET button again to enter the minutes setting mode.
5. The minutes will begin to flash, press the+ or – button to adjust the minutes up or down.
6. Press the SET button again to enter the program setting mode.
7. Press the+ button once to display the second setting ·1 OFF -:-·
8. Repeat the procedure to create the ·ow setting.
   • Repeat steps l thru 8 for additional ‘on/off’ settings.
   • Press the PROO button to exit the program setting mode.

Review 0n/Off Settings

It is important to review all settings, even if you only use one. to moke sure there are no extra, unintended settings. Press the PROO button once to display the first setting “1 ON”. Press the+ button to advance and cycle through the settings. Stop on any setting you want to change or remove.

1. To Change a Setting: press the SET button once to enter the timer program setting mode
2. To Remove or Restore a Setting: press the PROO button to display the first setting “1 ON” and press the+ button until the display shows the setting you want to remove. Press the RCL-DST button once to remove a setting. The display will replace the setting with dashes·-:-·. Press the RCL-DST button again to restore a setting (and press SET If you then want change the setting)

Daylight Savings Time Features

Press the RCI.-OST button to advance the time of day by one hour for daylight savings Home.  + l h” will appear in the lower left comer of the display. Press the button again to set the lime back one hour.

To Connect the Timer

• Plug the devise into the timer and tum the device on. Plug the timer into wall outlet.

To Override the Timer

Press the + button as necessary to display

• “ON” -the plugged In device is switched on permanently.
• “OFF” -the plugged In device is switched off permanently.
• “AUTO” – the plugged-in device follows your programmed timer settings.

www.colemancable.com

Woods 50007 Indoor 24-Hour Digital Timer 2-C User Manual

References

• User Manual