WEBIRD FEVER 01 Ski Sensor User Manual

WEBIRD-logo

WEBIRD FEVER 01 Ski Sensor

WEBIRD-FEVER-01-Ski-Sensor-product

Introduction

WEBIRD FEVER is a pair of wearable data acquisition devices (left foot+ right foot) with built-in gyroscopes, geomagnetic sensors, and barometers. It uses Bluetooth to collect data on the glider The raw data of snow is transmitted to the mobile app, and the app completes the data analysis and display. Sensors are worn on both feet to capture real-time gliding posture
The cost saving method generates professional skiing technical indicators such as the angle of the vertical blade, parallelism, and the proportion Of walking blade/rubbing snow.

Bid farewell to ” relying on feelings”: transform subjective feelings into objective data.
Accurate error correction: Accurately distinguish between Carving and Skidding, and identify plow marks.

Packing List

  • Left foot sensor (L)  xl
  • Right foot sensor (R)  xl
  • Fixed strap(For Skiing)   If necessary, please place a separate order
  • 1-to-2 data cable  xl
  • Instruction Manual  xl
  • After-sales card xl

Configuration

WEBIRD-FEVER-01-Ski-Sensor-7

Parameter

  • Sensor type 9-axis inertial measurement unit (3-axis accelerometer + 3-axis gyroscope + 3-axis magnetometer) + barometer (right foot only)
  • Sampling frequency  Low-power Bluetooth (BLE 5.0)
  • Communication method 100Hz
  • Waterproof rating IP65
  • Operating temperature -250C 450C
  • Battery capacity 400mAh
  • Weight Sensor: 38.5g/piece
  • Battery life > 30h

Instructions for Use

Charging
Use the included data cable and connect it to a Type-C power source to charge.
The sensors will power off automatically after full charge ended.

WEBIRD-FEVER-01-Ski-Sensor-1

Power On/Off

  • Power on: After inserting the sensors in the snow boots, short press the top button to power on;
  • power off: When the device is turned on, press and hold for 3 seconds until the red light goes outto turn it off;
  • Reset: In the event of a crash or freeze, press and hold the button for 8 seconds to force a reset and restart.

WEBIRD-FEVER-01-Ski-Sensor-2

Way of Wearing

  1. Fasten the sensor body into the base. For Snowboard: Insert the sensors in the left & right side of the snow boots; For Ski,
    Fix the straps (If necessary) on the snow boots, Insert the sensors into the heel of the snow boots.
  2. Wear the “L” sensor on the left foot, “R” sensor on the right foot.
    Tips: If the snow boot straps for ski is necessary, please order separately.

WEBIRD-FEVER-01-Ski-Sensor-3

Connect App

  1. Open Bluetooth and App on your phone
  2. Turn on the left and right sensors separately
  3. Search and connect devices within the app

WEBIRD-FEVER-01-Ski-Sensor-4

Lighting effects

WEBIRD-FEVER-01-Ski-Sensor-5

Precautions

  1. Wipe the charging contacts dry before charging
  2. Avoid violent impact
  3. When not in use for a long time, fully charge the device, turn it off, and store it. Recharge it every 3 months
  4. It is normal for large metal objects such as cable cars and steel frames to temporarily interfere with geomagnetic data.

This sensor table for alpine ski ng and snowboarding. By capturing the movements and postures during the sliding process in real time, combined with algorithms, it generates specialized data on the APP This sensor is designed to measure skiing technical indicators, aiming to assist in correcting skiing posture and improving skiing skills. It complies with FCC standards.

Limited Warranty

Except for the scope prohibited by applicable laws, WEBIRD’s products come with standard warranty, this warranty does not cover defects or physical damage resulting from misuse, negligence, improper repair, incorrect installation, modification, or accidental use by the manufacturer. If you have any product issues, please contact us via our website, email, or phone.

Use, Cleaning, and Maintenance

If your snow boots do not come with straps or do not have suitable straps, please purchase additional straps. Please make sure fix the sensors directly above the heel of the snow Skiing) or on the side of the snow boots(For Snowboard), so that the sensors capture your data accurately. f you need to clean the sensors, use only water and mild soap and use a clean soft cloth, and avoid using products containing alkali, ammonia, or acid solvents.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

This equipment complies with FCC radiation ensure limits set forth for an environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.

SCAN HERE TO DOWNLOAD APPWEBIRD-FEVER-01-Ski-Sensor-6

Documents / Resources

PDF thumbnailFEVER 01 Ski Sensor
User Manual · WEBIRD, GUANGZHOU CAOMING TECHNOLOGY CO. LTD., FEVER01, 2BY2C-FEVER01, Ski, Sensor

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.