Document

WAYTO

User Manual
5 IN 1 SUPER CHARGER

Specification

Capacity:20000mAh 3.85V 77Wh ±5%
Input: 100-240V~50/60Hz 0.5A Type-C Cable PD 5V  Direct Current3A/9V  Direct Current2A/12V 1. Direct Current5A
Charger mode Output:5V  Direct Current3A(Total)
Power bank Output: Type-C& Lightning Cable PD/PPS 5V  Direct Current2.4A/9V  Direct Current2.22A/12V  Direct Current1.67A(20W)
2xUSB Output: 4.5V  Direct Current5A/5V  Direct Current4.5A/9V  Direct Current2A/12V  Direct Current1.5A(22.5W)
MagSafe Wireless Output: 15W/10W/7.5W/5W
Total Output: Cable+2xUSB+Wireless:5V  Direct Current4.5A(22.5W)
Size: 125x72x33mm
Weight: 400g

Using the adapters

  1. UK/EU/AU adapters: Attach the appropriate adapter to the charging base/US adapter: pull the adapter out from the charging base then plug it into the plug socket and switch on the power.
  2. insert your USB cable into one of the USB ports and connect to your device.
  3. The light will turn blue for a moment and then turn green again to confirm that it’s charging.

WAYTO KP SUPER7 5 in 1 Super charger - fig1

Optional Plug for Global Travel ( US plug is standard in the package, more EU/AU/UK plug need additional cost if you need them.)

Function Description

WAYTO KP SUPER7 5 in 1 Super charger - fig2

a. Switch Press it once to turn on USB output and wireless charging output It automatically turns off in 30 seconds under the no-load status
b. Charging the LED digital power display blinks while charging It shows 100 after fully charged.
c. Wireless Charging Make sure your phone is equipped with QI wireless charging receiver, otherwise, additional wireless charging receiver is needed to install with your phone.

Working Mode

Dis-Charging:
*Qi wireless charging is 7.5W/10W/15W fast charge while using QI only, it becomes 5W when more USB output in use simultaneously
* Power Delivery (PD) is 20W max while using Type-C&Lightning Cable output only, it becomes common 5V 4.5A max when either QI wireless charging or USB-A output in use simultaneously. Three outputs intelligently distribute the current
Charging:
* It’s 5V 3A when use AC plug charging mode, charging time is about 5.5 hours
* Support pass-through charging, Type-C&USB-A output is 5V and intelligent current.

AC Charge For Power Bank

Insert the plug into the socket, and the power bank will be charged.

WAYTO KP SUPER7 5 in 1 Super charger - fig3

Car Charge For Power Bank

WAYTO KP SUPER7 5 in 1 Super charger - fig4

Connect the built-in Type-C cable with car charger, it will charge your supercharger power bank.

Charge through the wireless charging function

WAYTO KP SUPER7 5 in 1 Super charger - fig5

Put the Qi-enabled mobile devices on the supercharger, it will charge your devices after turning on the power switch. It supports MagSafe charging for the latest phones like iPhone 12 and 13.
Attention! When using the built-in cable charging, you cannot put the phone on the wireless charging area, otherwise, it turns to slow charging.

Use supercharge to charge other devices
Connect your mobile device with the built-in charging cable, press the power button and the Super Charger starts charging your device.

WAYTO KP SUPER7 5 in 1 Super charger - fig6

Built-in charging cable USB-C PD20W is suitable for charging laptops up to 30W, not recommended for charging higher power laptops.
Attention! When the iPhone is quickly charged to 80%, it will automatically switch to slow charging mode without current. The power bank will automatically shut down and you need to press the switch again to keep charging the iPhone to 100%.
AC Charge devices through the adapter
Connect a charging cable and charge your mobile device directly. Press the power button and the super charger starts to charge your devices.WAYTO KP SUPER7 5 in 1 Super charger - fig7

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.
    The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction

Documents / Resources

WAYTO KP-SUPER7 5-in-1 Super charger [pdf] User Manual
KP-SUPER7, KPSUPER7, 2A59PKP-SUPER7, 2A59PKPSUPER7, KP-SUPER7 5-in-1 Super charger, KP-SUPER7, 5-in-1 Super charger

Leave a comment

Your email address will not be published.