WEEE Number: 80133970
INSTALLATION INSTRUCTION
RECESSED LINEAR LIGHTS
VT-7-41

V-TAC Recessed Linear Lights -
V-TAC Recessed Linear Lights -samsung

  • Suitable for 10-12 hours daily, usage of the product for 24 hours a day would void the warranty

TECHNICAL DATA

SKI PAWER(W) COLOR TEMPERATURE(K) LUMINOUS(I’m) BODYCOLOR IP INPUT POWER CRI PF DIMENSION(mm)
380 40W 4000K 3200Lumens SILVER 1P20 IP20 AC:200-240V,S0/60Hz >80 >0.9 1210x70x6Onim
381 40W 4000K 3200Lumens WHITE 1P20 AC:200-240V.50/60Hz >80 >0.9 1210x70x6Onim

INSTALLATION DIAGRAM

V-TAC Recessed Linear Lights -installation diagramV-TAC Recessed Linear Lights -installation diagram 1

INTRODUCTION & WARRANTY

Thank you for selecting and buying the V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installing and keep this manual handy for future reference. If you have any other queries, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at your best.

The warranty is valid for 5 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours of Daily operation. Usage of product for 24 hours a day would void the warranty. This product is warranted for manufacturing defects only.

WARNING!

Luminaire with a non-replaceable and non-user-replaceable light source, the installation sheet shall contain the substance of the following information:

  • For non-replaceable light sources:
    The light source of this luminaire is not replaceable; when the light source reaches its end of life, the entire luminaire must be replaced
  • For non-user-replaceable light sources:
    The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similarly qualified person.

INSTALLATION INSTRUCTION

Step 1: Drill a hole of 6mm diameter on the ceiling
Step 2: Push the plastic fitting into the hole
Step 3: Tightly firm locked 4 to 2
Step 4: Put 7 bottom plates and insert the lamp body, keep the suspension cables in a vertical direction.
Step 5: Hang the lamp using the hanging wire.

In case of any query/issue with the product, please reach out to us at: [email protected] For More products range, inquiry please contact our distributor or nearest dealers. V-TAC EUROPE LTD Bulgaria, Plovdiv 4000, bul.L.Karavelow 9B

Documents / Resources

V-TAC Recessed Linear Lights [pdf] Installation Guide
V-TAC, VT-7-41, Linear Lights

Leave a comment

Your email address will not be published.