V I V O MOUNT-VP08B-W Extending Ceiling Projector Tray Mount
SKU: MOUNT-VP08B/W
Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product.
https://vivo-us.com/products/mount-vp08b
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST
www.vivo-us.com
Chat live with an agent!
WARNING
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use.
WARNING: CHOKING HAZARD
SMALL PARTS – NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
PACKAGE CONTENTS
- A (x1) Mount
- B (x1) Tray
- S-A (x2) Plastic Spacer
- S-B (x2) Threaded Plate
- S-C (x4) M5x12mm Screw
- W-A (x4) ST6X55mm Screw
- W-B (x4) Concrete Spacer
- M-C (x4) M6 Washer
- T-A (x1) 4mm Allen Wrench
NOTE: SOME HARDWARE INCLUDED MAY NOT BE USED
CAUTION!
DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR CEILING CONSTRUCTION. USE WOOD STUDS TO MOUNT. We include mounting for brick and concrete. If unsure, please contact us at vivo-us.com, email at help@vivo-us.com, or call us at 309-278-5303.
TOOLS NEEDED
- Drill
- Phillips Screwdriver
- Pencil
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury
ASSEMBLY STEPS
STEP 1
OPTION A:
Run cables through arm (A).
OPTION B:
If running cables through ceiling, pull cables through top plate of arm (A)
OPTION A: Drywall Mounting
Use top plate of Mount (A) to mark mounting holes on ceiling. Using a 3/16” drill bit, drill approximately 2.2” into ceiling stud. Put Mount (A) in place and mount to the pre-drilled holes using ST6x55 Screws (W-A) and M6 Washers (W-C) as shown below.
OPTION B: Concrete/Brick Mounting
Use top plate of Mount (A) to mark mounting holes on ceiling. Using a ⅜” drill bit, drill approximately 2.4” into ceiling. Use Concrete Anchors (W-B), ST6x55mm Screws (W-A), and M6 Washers (W-C) to mount Mount (A) as shown below.
STEP 3
Use two upper set of holes on the bottom of Mount (A) to install two M5x12mm Screws (S-C), Plastic Spacer (S-A), and Threaded Plate (S-B) using 4mm Allen Wrench (T-A), leaving a 4mm screw gap.
Latch Shelf (B) onto previous installed screws and install remaining M5x12mm Screws (S-C) in remaining set of holes. Secure all screws with 4mm Allen Wrench )T-A).
STEP 4
To adjust height, use 4mm Allen Wrench (T-A) to loosen set screw in back of mount. Adjust height and re-tighten to secure.
Place projector on assembly and connect power with previous installed cables.
Open Monday – Friday 7:00am – 7:00pm CST,
our dedicated support team can offer immediate assistance with rapid response times. If any parts are received damaged or defective, please contact us. We are happy to replace parts to ensure you have a fully functioning product.
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
 | 309-278-5303 | AVG. RESOLUTION TIME (within office hrs): 5M 4S |
| www.vivo-us.com Chat live with an agent! | AVG. RESOLUTION TIME (within office hrs): < 15 M |
 | help@vivo-us.com | AVG. RESPONSE TIME (within office hrs): 1HR 8M – 23% within < 15m – 38% within < 30m – 61% within < 1hr – 83% within < 2hr -92% within < 3hr |
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com
Documents / Resources
 | V I V O MOUNT-VP08B-W Extending Ceiling Projector Tray Mount [pdf] Instruction Manual MOUNT-VP08B-W Extending Ceiling Projector Tray Mount, MOUNT-VP08B-W, Extending Ceiling Projector Tray Mount, Ceiling Projector Tray Mount, Projector Tray Mount, Tray Mount, Mount |
