RH TEEN 1960-yillar kanistr topshiriqlar jadvali Lamp Simsiz zaryadlovchini ishlatish bo'yicha qo'llanma bilan

1960-yillar kanistr vazifalari jadvali Lamp simsiz zaryadlovchi bilan

1960s CANISTER TASK TABLE LAMP WITH WIRELESS CHARGING – ASSEMBLY INSTRUCTIONS

PARTS ENCLOSED:

XAVFSIZLIKNING MUHIM YO'LLARI:

(A) Lamp shade (1) (B) Arm handle (1) (C) Lamp base (1) (D) ON/OFF rotating knob (E) Plug (F) Arm knob (1) (G) Shade joint (1) (H) LED bulb (1) (I) Charging pad (1)

For safety purposes, this lamp is equipped with a polarized plug (one blade is wider than the other). If the plug does not fit securely into your outlet, do not force it – contact a professional electrician. Use the plug with an extension cord only if it can be fully inserted into the cord’s socket. Never alter the plug in any way.
Bu lamp has been rated for up to (1) 5w max LED bulb (included); only an LED bulb can be used. To avoid the risk of fire, do not exceed the recommended wattage.
Ogohlantirishlar:

1960s CANISTER TASK TABLE LAMP Simsiz zaryad bilan

All wires are connected. When unpacking, be careful not to pull wires, as a bad connection may result. Do not connect electricity until your lamp is fully assembled. To reduce the risk of fire, electrical shock, or personal injury, always turn off the lamp and allow it to cool prior to replacing the lightbulb. Do not touch bulb when lamp is turned on or look directly at lit bulb. Keep flammable materials away from lit bulb.
THIS PRODUCT IS NOT A TOY AND HAS NO PLAY VALUE.

OGOHLANTIRISH: STRANGULASYON XAVFI
Keep cord at least 3 feet away from cribs, bassinets, and toddler beds. Keep out of reach of children under 3 years of age.

ASSEMBLY & INSTALLATION:
1. Carefully remove all parts from the box and remove plastic coverings. 2. Carefully place the lamp base (C) on a tabletop. 3. Adjust the lamp shade (A) with shade joint (G) using arm knob (F) and arm
handle (B) to get the desired angle and height. Follow the steps below to adjust the knob. A. To adjust the position of the arm, lift up the arm handle to loosen the arm knob. B. Loosen the arm knob and adjust the arm to the desired angle, then tighten the knob. You don’t need to lock the knob with much force; just push the arm handle down a little to hold the lamp in position. 4. Insert the LED bulb (H) into the socket and turn to tighten. 5. Insert plug (E) into proper electrical outlet and test the lamp. 6. Turn the rotating on-off switch (D) on the base to turn the light on or off. 7. Place your cell phone on the charging pad (I) to charge as needed. 8. Assembly is complete.

G'amxo'rlik ko'rsatmalari:
Do not use polishes or cleaners, as they may damage the finish. Wipe clean with a soft, dry cloth.

1960s CANISTER TASK TABLE LAMP WITH WIRELESS CHARGING – ASSEMBLY INSTRUCTIONS
Ushbu qurilma FCC qoidalarining 15-qismiga mos keladi. Ishlash quyidagi ikki shartga bo'ysunadi: (1) ushbu qurilma zararli shovqinlarni keltirib chiqarmasligi mumkin va (2) ushbu qurilma qabul qilingan har qanday shovqinlarni, shu jumladan kiruvchi ishlashga olib kelishi mumkin bo'lgan shovqinlarni qabul qilishi kerak.
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and the receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
Ushbu uskuna nazoratsiz muhit uchun belgilangan FCC radiatsiya ta'sir qilish chegaralariga mos keladi. Ushbu uskuna radiator va tanangizning istalgan qismi o'rtasida kamida 20 sm masofada o'rnatilishi va ishlatilishi kerak.
Ushbu uskuna nazoratsiz muhit uchun belgilangan ISED RSS-102 radiatsiyaviy ta'sirlanish chegaralariga mos keladi. Ushbu uskunani radiator bilan tanangizning istalgan qismi o'rtasida minimal 20 sm masofada o'rnatish va ishlatish kerak.
Conformer aux exigences de conformité CNR 102 RF ekspozitsiyasi, masofa 20 sm dan oshmasligi kerak.
Ushbu qurilmada Kanadaning Innovatsiya, Fan va Iqtisodiy Taraqqiyot RSS(lar)iga mos keladigan litsenziyasiz uzatuvchi(lar)/qabul qiluvchi(lar) mavjud. Ishlash quyidagi ikkita shartga bog'liq: Ushbu qurilma shovqinga olib kelmasligi mumkin. Ushbu qurilma har qanday shovqinni, shu jumladan qurilmaning istalmagan ishlashiga olib kelishi mumkin bo'lgan shovqinlarni qabul qilishi kerak.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : L’appareil ne doit pas produire de brouillage; L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Hujjatlar / manbalar

RH TEEN 1960-yillar kanistr topshiriqlar jadvali Lamp simsiz zaryadlovchi bilan [pdf] Foydalanish boʻyicha qoʻllanma
TL1071, 2AZGPTL1071, 1960s Canister Task Table Lamp with Wireless Charger, 1960s, Canister Task Table Lamp simsiz zaryadlovchi bilan

Izoh qoldirish

Sizning email manzilingiz chop qilinmaydi.