MEEC TOOLS 018722 ipni ta'mirlash to'plami uchun qo'llanma

XAVFSIZLIK YO'LLARI

Wear safety glasses when drilling – risk of eye damage

Belgilar

Ko'rsatmalarni o'qing.
Tegishli ko'rsatmalarga muvofiq tasdiqlangan.
Xavfsizlik ko'zoynaklarini taqinglar.
Mahalliy qoidalarga muvofiq tashlangan mahsulotni qayta ishlang.

TEXNIK MA'LUMOTLAR

Ip qo'shish                                              Uzunlik.

018722 M6 x 1.0                                           6.3 mm
018723 M8 x 1.25                                         8.3 mm
018724 M10 x 1.5                                         10.4 mm
018725 M12 x 1.75                                       12.4 mm

TA'RIFI

Complete thread repair kit with taps, installation tool and inserts.
Tool and drill made of HSS steel. The inserts are made of stainless steel 304. Supplied in sheet metal box.

  1. Chuqurlikni sozlash yoqasi
  2. O'rnatish vositasi
  3.  mashg'ulot
  4. jo'mrak
  5. Ip qo'shimchalari
   ANJIR. 1

USE IMPORTANT:

After drilling or threading operations all metal shavings must be carefully removed with compressed air or a magnet.

  1. Drill out the damaged thread or screw with the spiral drill (3).
  2. Cut new thread in the drilled hole with the tap. Use a suitable cutting fluid for best results.
  3. Put the thread insert on the installation tool. The driving tap on the thread insert must be put in the tap groove on the installation tool. Adjust the depth stop ring. Fit the thread insert in the newly cut thread and screw it carefully in place. 4. Snap off the installation tap with pliers.

    ESLATMA:

    Depending on the application a magnet may be need to remove the snapped installation tap. For larger sizes of thread, especially spark plug thread, the installation tap should be
    snapped and removed with snipe nose pliers.

    ESLATMA:

    Tegishli kesish suyuqligidan foydalaning va tishlash samarali bo'lishini ta'minlash uchun har bir to'liq burilish uchun jo'mrakni soat yo'nalishi bo'yicha yarim burilish orqaga burang.
    – For blind holes, set the position for the depth adjustment collar (1) on the installation tool (2) so that the tap does not seat and stick out over the upper surface of the thread hole. Make sure that the thread insert tang (A) comes in the slot in the installation tool (2). FIG. 2

  4. Twist the insert in the hole to the requisite depth and remove the installation tool (2).
  5. Tangni olib tashlash uchun mos zımba va bolg'adan foydalaning.

XIZMAT KO'RSATISH

Wipe the tools and thread inserts after use to clean them from
oil, dirt and shavings. Do not wash with degreaser.

Saqlash

Qismlarni metall qutida saqlang.

 

Ushbu qo'llanma haqida ko'proq o'qing va PDF-ni yuklab oling:

Hujjatlar / manbalar

MEEC TOOLS 018722 ipni ta'mirlash to'plami [pdf] Foydalanish boʻyicha qoʻllanma
018722, 018723, 018724, Thread Repair Kit, Repair Kit, 018722, Thread Repair

Izoh qoldirish

Sizning email manzilingiz chop qilinmaydi.