Universal Remote Control URC1056 User Guide
Universal Remote Control URC1056

Step 1 Installing Batteries

  1. Remove battery cover.
    Removing Cover
  2. Insert 2 AA batteries. Match the + and – marks.
    Inserting Batteries
  3. Replace battery cover.
    Replace Cover

Step 2 Setup Television Control

  1. Press the TV mode key.
    TV mode key
  2. Press and hold SETUP until TV mode key blinks twice.
    Setup Button
  3. Enter 1st TV code for your TV brand from the code list.
    Remote Keys
  4. Press Ch+ repeatedly until your device turns ON or OFF.
    Chanel Button
  5. To save the working code, press and hold SETUP until the LED blinks twice.
    Warning Icon

Step3 Setup Control of Other Equipment

  1. Press the mode key for the device you wish to setup.
    Mode Keys
  2. Press and hold SETUP until the mode key blinks twice.
    Setup Button
  3. Enter 1st code for your brand from the matching code list.
    Tv Code List
  4. Press power key to test with your equipment. If the device turns off, setup is complete.
    Inductions
  5. If device does not turn off, then repeat STEP3 using the next code for your brand.
    Warning Icon

Step4 Locking Volume Controls to Audio Device

Note: Volume Control defaults to TV. Perform this step only if you wish to use an AUDIO receiver, Amp, or home theater surround system for Volume Control when watching cable.

  1. Press and hold SETUP until the mode key blinks twice.
    Setup Button
  2. Enter 9-9-3
    Remote Keys
  3. Press the AUD mode key to lock volume to AUDIO.
    AUD key

TROUBLESHOOTING

Problem: Mode key does not blink when a key is pressed.
Solution: Replace batteries.
Problem: Mode key blinks, but remote does not control my equipment.
Solution: Press correct mode key and point remote at equipment you need to control.
Problem: Tried all codes for my brand of device and none work.
Solution: Try CODE SEARCH (STEP 2a)  method or go to www.urcsuppport.com for model-based search.
Problem: I want to swirch BOLUME LOCK from AUD to TV control.
Solution: Follow STEP-4, but press the TV mode key instead of AUD mode key.
Problem: My TV power turns off when my cable power turns on.
Solution: Manually press the power button on the front of the cable box or your TV to get back in sync.

Web for Help: WWW.URCSUPPORT.COM

Universal Remote Control URC1056 User’s Guide – Optimized PDF
Universal Remote Control URC1056 User’s Guide – Original PDF

Leave a comment

Your email address will not be published. Required fields are marked *