ULINE Tip and Roll Kit For 3-Row
Bleachers H-4755 User Guide
WARNING! Due to outdoor wind hazards, bleachers with tip and roll kits, while suitable for indoor or outdoor use, should only be tipped up onto the casters when indoors in order to prevent them from tipping back over unintentionally.
TOOLS NEEDED
PARTS
ASSEMBLY
1a. Each of the three bleacher frames has four predrilled holes along the bottom. (See Figure 1)
1b. Attach four rubber foot pads to the predrilled holes using a screw, washer and 5/16″ flange nut. (See Figure 2)
2a. Each of the three bleacher frames has two predrilled holes along the back. (See Figure 3)
2b. Insert the casters into the predrilled holes and attach using 3/8″ flange nuts. (See Figure 4)
NOTE: Casters with brakes go on the bottom holes.NOTE: Casters go on the outside frames only. There are no casters on the middle frame.
Documents / Resources
 | ULINE Tip and Roll Kit For 3-Row Bleachers H-4755 [pdf] User Guide Tip and Roll Kit For 3-Row Bleachers, H-4755 |
