1. Вступ
This instruction manual provides essential information for the safe installation, operation, and maintenance of your Leviton 7591-PLG 15-Amp, 125-Volt Smart Lock GFCI Single Outlet with LED Pilot Light. Please read all instructions carefully before beginning installation or use. Retain this manual for future reference.
2. Особливості продукту
- Heavy Duty "Triple Wire" Contacts: Ensures secure and reliable electrical connections.
- Thick-Walled, Impact-Resistant Thermoplastic Nylon Cover and Body: Designed for durability and to withstand abuse in various environments.
- Patented Lockout Feature: Prevents the GFCI from resetting if it is not functioning properly or is miswired due to reversal of line and load leads, enhancing safety.
- Triple-Drive Combination Terminal Screws: Facilitates easier and more versatile wiring connections.
- High-Visibility LED Pilot Light: Clearly indicates when the circuit is live and the GFCI is providing protection.
3. Інформація про безпеку
WARNING: TO AVOID FIRE, SHOCK, OR DEATH, TURN OFF POWER AT CIRCUIT BREAKER OR FUSE BOX AND TEST THAT POWER IS OFF BEFORE WIRING!
- Встановлення має виконувати кваліфікований електрик відповідно до всіх національних та місцевих електротехнічних норм.
- Не встановлюйте у вологих місцях, якщо це не призначено для такого використання.
- Забезпечте належне заземлення.
- Always test the GFCI outlet monthly to ensure proper operation.
- This device is designed to protect against ground faults, not against electrical shock from contact with both circuit conductors (hot/neutral) or from short circuits.
4. Налаштування (Встановлення)
Before installation, ensure the power to the circuit is OFF at the service panel. Use a voltage tester to confirm the circuit is de-energized.
Інструкції з підключення
The Leviton 7591-PLG GFCI outlet has LINE and LOAD terminals. It is crucial to connect the incoming power (LINE) to the correct terminals and the outgoing power (LOAD) to the appropriate terminals if protecting downstream outlets.
Image: Leviton 7591-PLG Smart Lock GFCI Single Outlet in Gray. This image shows the front view of the GFCI outlet, highlighting its single receptacle and the test/reset buttons.
- Підготуйте дроти: Strip approximately 1/2 inch (12.7 mm) of insulation from the ends of the circuit wires.
- Визначення проводів: Identify the LINE (incoming power from breaker) and LOAD (outgoing power to other outlets) wires. Also identify the hot (black), neutral (white), and ground (green/bare copper) wires.
- Підключіть дріт заземлення: Connect the bare copper or green insulated ground wire from the circuit box to the green ground screw on the GFCI outlet.
- Підключення лінійних проводів: Connect the incoming hot (black) LINE wire to the brass LINE terminal screw and the incoming neutral (white) LINE wire to the silver LINE terminal screw.
- Підключення проводів НАВАНТАЖЕННЯ (необов'язково): If protecting downstream outlets, connect the outgoing hot (black) LOAD wire to the brass LOAD terminal screw and the outgoing neutral (white) LOAD wire to the silver LOAD terminal screw. If not protecting downstream outlets, cap the LOAD wires individually.
- Безпечна розетка: Carefully fold wires into the wall box and secure the GFCI outlet with mounting screws.
- Встановлення настінної панелі: Прикріпіть настінну пластину.
- Відновлення живлення: Turn power ON at the circuit breaker.
5. Інструкція з експлуатації
Початкове включення
After installation and restoring power, the GFCI outlet should be in a tripped state (RESET button will be out). Press the RESET button firmly to restore power to the outlet. The LED pilot light will illuminate, indicating the GFCI is functioning and providing protection.
Testing the GFCI
It is recommended to test the GFCI monthly to ensure proper operation.
- Вилка алamp or other device into the GFCI outlet and turn it ON.
- Press the TEST button on the GFCI. The device should trip, and the lamp/device should turn OFF. The RESET button should pop out.
- Press the RESET button firmly. The lamp/device should turn ON.
- If the GFCI fails to trip or reset, it may be faulty or improperly wired. Discontinue use and consult a qualified electrician.
Resetting the GFCI
If the GFCI trips (RESET button pops out), it indicates a ground fault has occurred. To restore power, unplug any devices from the outlet, then press the RESET button firmly. If the GFCI immediately trips again, there may still be a ground fault or a wiring issue. Investigate the cause before attempting to reset again.
6. Технічне обслуговування
The Leviton 7591-PLG GFCI outlet requires minimal maintenance. The primary maintenance task is the monthly testing procedure described in the Operating Instructions section. Keep the outlet and surrounding area clean and free from debris. Do not use abrasive cleaners or solvents.
7. Вирішення проблем
| проблема | Можлива причина | Рішення |
|---|---|---|
| GFCI не скинеться. | No power to the GFCI; GFCI is miswired (LINE/LOAD reversed); Internal fault; Downstream ground fault. | Check circuit breaker. Verify LINE/LOAD wiring. If miswired, correct immediately. Unplug all devices from the GFCI and any downstream outlets, then try to reset. If it still won't reset, replace the GFCI. |
| GFCI часто спрацьовує. | Ground fault in connected appliance; Ground fault in downstream wiring/outlets; Moisture in circuit. | Unplug appliances one by one to identify the faulty device. Inspect wiring for damage or moisture. If the problem persists, consult an electrician. |
| No power from GFCI, but RESET button is in. | No power to the GFCI; Internal fault. | Check circuit breaker. Test the GFCI (press TEST, then RESET). If it doesn't respond, the GFCI may be faulty and needs replacement. |
| LED Pilot Light is off. | GFCI is tripped; No power to the GFCI; LED malfunction. | Press RESET. Check circuit breaker. If the GFCI functions but the LED remains off, the LED may be faulty, but the GFCI protection should still be active. |
8. Технічні характеристики
| Специфікація | Деталь |
|---|---|
| Бренд | Левітон |
| Модель | 7591-PLG |
| Ampераж | 15 Amps |
| томtage | 125 вольт |
| Загальна кількість розеток | 1 |
| Колір | Сірий |
| матеріал | Nylon (Thermoplastic) |
| Тип роз'єму | Підключити |
| Тип штепсельної вилки | Type A - 2 pin (North American) |
| Сумісні пристрої | всі |
| UPC | 078477409992 |
| ASIN | B003CYKABU |
9. Інформація про гарантію
Цей продукт Leviton покривається 2-річна обмежена гарантія. For specific terms and conditions, please refer to the official Leviton warranty documentation or contact Leviton customer support. This warranty typically covers defects in materials and workmanship under normal use and service.
10. Підтримка
For technical assistance, troubleshooting, or warranty claims, please contact Leviton customer support:
- Webсайт: Відвідайте офіційний Левітон website for FAQs, product documentation, and support resources.
- телефон: Зверніться до розділу контактів на сайті Leviton. webсайт з номерами телефонів служби підтримки клієнтів.
- Інтернет-ресурси: Відвідайте магазин Leviton на Amazon