Turbosound TMS Series Full Range Loudspeakers and Subwoofers

Product Information

Specifications

• Model: TVX/TMS Series
• Models: TVX122M, TVX152, TVX118B, TMS122M, TMS152, TMS153, TMS118B, TMS218B
• Type: Full Range Loudspeakers and Subwoofers
• Applications: Portable PA and Installation

Product Usage Instructions

Important Safety Instructions

• Terminals marked with the symbol carry electrical current of sufficient magnitude to constitute a risk of electric shock.
• Use only high-quality commercially-available speaker cables with pre-installed plugs.
• All installations or modifications should be performed by qualified personnel.

Caution Instructions

• Do not remove the top cover or rear section to reduce the risk of electric shock.
• Avoid exposing the appliance to rain and moisture to prevent fire or electric shock.
• Do not block ventilation openings and install according to manufacturer’s instructions.
• Protect the power cord from being walked on or pinched at plugs.

Additional Instructions

• Read and keep the instructions for future reference.
• Clean the product only with a dry cloth.
• Use only attachments specified by the manufacturer.
• Unplug during lightning storms or long periods of non-use.
• Refer servicing to qualified personnel in case of damage or abnormal operation.

Frequently Asked Questions (FAQ)

• Q: Can I use any type of speaker cables with the product?
  
  • A: It is recommended to use high-quality commercially-available speaker cables with pre-installed plugs to ensure safety and optimal performance.
• Q: What should I do if the product gets exposed to moisture?
  
  • A: If the product gets exposed to moisture, immediately disconnect it from power and refer servicing to qualified personnel to avoid any risks of electric shock or damage.
• Q: Can I clean the product with a damp cloth?
  
  • A: No, it is advised to clean the product only with a dry cloth to prevent any damage due to moisture.

Important Safety Instructions

CAUTION
RISK OF ELECTR IC SHOCK!
DO NOT OPEN

Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality commercially-available speaker cables with plugs pre-installed. All other installation or modification should be performed only by qualified personnel.

This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure – voltage that may be sufficient to constitute a risk of shock.

This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. Please read the manual.

Caution
To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside. Refer servicing to qualified personnel.

Caution
To reduce the risk of fi re or electric shock, do not expose this appliance to rain and moisture.
The apparatus shall not be exposed to dripping or splashing liquids and no objects filled with liquids, such as vases, shall be placed on the apparatus.

Caution
These service instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not perform any servicing other than that contained in the operation instructions. Repairs have to be performed by qualified service personnel.

1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug.
   A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third
   prong are provided for your safety. If the provided plug does not fi t into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
11. Use only attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
15. The apparatus shall be connected to a MAINS socket outlet with a protective earthing connection.
16. Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
17. Correct disposal of this product: This symbol indicates that this product must not be disposed of with household waste, according to the WEEE Directive (2012/19/EU) and your national law.

This product should be taken to a collection center licensed for the recycling of waste electrical and electronic equipment (EEE). The mishandling of this type of waste could have a possible negative impact on the environment and human health due to potentially hazardous substances that are generally associated with EEE. At the same time, your cooperation in the correct disposal of this product will contribute to the efficient use of natural resources.

For more information about where you can take your waste equipment for recycling, please contact your local city office, or your household waste collection service.

LEGAL DISCLAIMER
MUSIC Group accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein. Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. MIDAS, KLARK TEKNIK, TURBOSOUND, BEHRINGER, BUGERA and DDA are trademarks or registered trademarks of MUSIC Group IP Ltd. © MUSIC Group IP Ltd. 2014 All rights reserved.

LIMITED WARRANTY

For the applicable warranty terms and conditions and additional information regarding MUSIC Group’s Limited Warranty, please see complete details online at music-group.com/warranty . Thank you for choosing a TURBOSOUND loudspeaker product for your application. If you would like further information about this or any other product, please visit our website at turbosound.com .

Unpacking the Loudspeaker
After unpacking the unit, please check carefully for damage. If damage is found, please notify your supplier at once. You, the consignee, must instigate any claim. Please retain all packaging in case of future return shipment.

System Requirements

• TVX122M, TVX152, TMS122M, TMS152 and TMS153 are switchable passive / bi-amp 2-way loudspeakers. Passive operation (full range or with a subwoofer) requires 1 amplifier channel and 1 controller channel. The input signal is divided between the low-frequency and high-frequency drivers internally with a passive crossover.
• Bi-amp operation (full range or with a subwoofer) requires 2 amplifier channels and 2 controller channels, one for low frequencies one for high frequencies. The input signal is divided between the low frequency and high frequency drivers in the controller and the individual amplified signals are fed to the speaker input.
• TVX118B, TMS118B and TMS218B subwoofers have a switchable input to allow operation with the satellite speakers using a single four core cable run. Operation requires 1 amplifier channel and
  1 controller channel.
• Correct controller settings for all models operation and with subwoofers can be downloaded from turbosound.com and are also available as presents for the LMS series controllers. To avoid wasting amplifier power, you should use heavy-duty speaker cable with a minimum wire size of 1.5 mm² (16 AWG), and preferably 2.5 mm² (14 AWG) for longer runs. For the TMS153 and TMS218B, use 4.5 mm² (10-12 AWG) where possible. For extreme cable lengths, be aware of cable impedance and resistive losses. Always observe the correct polarity.
• The TVX122M and TMS122M 2-way systems double effectively as wedge monitors. The TVX122M and the TMS122M both provide 30° and 60° wedge angles from the stage.

Amplifier Considerations

The TVX and TMS series loudspeakers are optimized for use with the TURBOSOUND T series amplifiers with the LMS series controllers. A full range of DSP settings to suit any configuration are provided for download on the TURBOSOUND website. The use of third party amplifi cation and processing is only advised using the matrix of manual settings as well as the limiter calculator provided on the TURBOSOUND website. The TVX and TMS series loudspeaker enclosures should be driven by high quality power amplifiers designed for true professional use. Power amplifiers should be capable of delivering long term broadband power equal to half the loudspeaker’s peak power rating at its stated nominal impedance. The use of underpowered amplifiers must be avoided as heavily clipped signals can cause permanent loudspeaker damage. Limiters, crossovers and equalization points must be set in accordance with the settings provided on the TURBOSOUND website. This will ensure the optimum sound quality and long-term reliability as well as protection from damage.

Neutrik speak ON* NL4 locking input connector(s) are provided, allowing options for input and link, passive, and bi-amp operation.

Connections

Models: TVX122M, TVX152, TMS122M, TMS152, TMS153

Models: TVX118B, TMS118B, TMS218B

Mounting and Fixing

TVX and TMS full-range series cabinets are designed with multiple internal rigging points to suit many possible mounting methods in permanent installations.

Suspending with Eyebolts

• TVX and TMS cabinets can be suspended using optional eyebolts coupled to the internal rigging points provided on the top, bottom and sides and back. The simplest method is to use the two rigging points on the top and a single pull-back rigging point in the centre of the rear panel.
• Remove the appropriate countersunk screws and replace them with shoulder eyebolts, which must have a thread length of at least 18 mm.
• Use the rear rigging point to angle the cabinet for optimum room coverage. Cabinets may be hung upside down if required.

IMPORTANT NOTE: The mounting of a permanently installed sound system may be dangerous unless undertaken by qualified personnel with the required experience and certification to perform the necessary tasks.

• Walls, floors or ceilings must be capable of safely and securely supporting the actual load. The mounting accessory used must be safely and securely fixed both to the loudspeaker and to the wall, floor or ceiling.
• When mounting rigging components on walls, floors or ceilings, ensure that all fixings and fasteners used are of an appropriate size and load rating. Wall and ceiling claddings, and the construction and composition of walls and ceilings, all need to be taken into account when determining whether a particular fixing arrangement can be safely employed for a particular load. Cavity plugs or other specialist fixings, if required, must be of an appropriate type, and must be fitted and used in accordance with the maker’s instructions.
• The operation of your speaker cabinet as part of a fl own system, if installed incorrectly and improperly, can potentially expose persons to serious health risks and even death. In addition, please ensure that electrical, mechanical and acoustic considerations are discussed with qualified and certified (by local state or national authorities) personnel prior to any installation or flying.
• Make sure that speaker cabinets are set up and fl own by qualified and certified personnel only,
  using dedicated equipment and original parts and components delivered with the unit. If any parts or components are missing please contact your dealer before attempting to set up the system.
• Be sure to observe the local, state and other safety regulations applicable in your country. MUSIC Group, including the MUSIC Group companies listed on the enclosed “Service Information Sheet”, assumes no liability for any damage or personal injury resulting from improper use, installation or operation of the product. Regular checks must be conducted by qualified personnel to ensure that the system remains in a secure and stable condition. Make sure that, where the speaker is fl own, the area underneath the speaker is free of human traffic. Do not fl y the speaker in areas that can be entered or used by members of the public.
• Speakers create a magnetic field, even if not in operation. Therefore, please keep all materials that can be affected by such fields (discs, computers, monitors, etc) at a safe distance. A safe distance is usually between 1 and 2 metres.

Technical Specifications

Other important information

Important information

1. Register online. Please register your new MUSIC Group equipment right after you purchase it by visiting turbosound.com . Registering your purchase using our simple online form helps us to process your repair claims more quickly and efficiently. Also, read the terms and conditions of our warranty, if applicable.
2. Malfunction. Should your MUSIC Group Authorized Reseller not be located in your vicinity, you may contact the MUSIC Group Authorized Fulfiller for your country listed under “Support” at turbosound.com .
   Should your country not be listed, please check if your problem can be dealt with by our “Online Support” which may also be found under “Support” at turbosound. com. Alternatively, please submit an online warranty claim at turbosound. com BEFORE returning the product.
3. Power Connections. Before plugging the unit into a power socket, please make sure you are using the correct mains voltage for your particular model. Faulty fuses must be replaced with fuses of the same type and rating without exception.

turbosound.com

Documents / Resources

Turbosound TMS Series Full Range Loudspeakers and Subwoofers [pdf] User Guide TVX122M, TVX152, TVX118B, TMS122M, TMS152, TMS153, TMS118B, TMS218B, TMS Series Full Range Loudspeakers and Subwoofers, TMS Series, Full Range Loudspeakers and Subwoofers, Loudspeakers and Subwoofers, Subwoofers

References

• User Manual