Tribit BTS25S Portable Wireless Speaker logoTribit BTS25S Portable Wireless SpeakerTribit BTS25S Portable Wireless Speaker image

Safety Precautions

  • Avoid dropping the speaker on the floor.
  • Do not try to disassemble or repair the speaker unless you are a technician.
  • Do not submerge the speaker in water.
  • Never expose the speaker to extremely high or low temperatures.
  • Stop use immediately if a thunderstorm happens.
  • Do not clean its surface with any corrosive cleanser or other chemical solutions.

Specifications

  • Bluetooth version: vs.a
  • Bluetooth profile: A2DP, AVRCP, HFP, HSP
  • Driver: 2 x CD45mm Passive radiator
  • Output power: 2 x 12W
  • Signal-to-noise ratio• 80dB
  • Frequency response: 80-20KHz
  • attery: 2×3.7V / 2200mAh
    Music playtime: Up to 20 hours I vary by volume level and music files)
  • Charging time: 4 [email protected]/1.5A
  • Dimensions: 65x198x68 mm/ 2.56×7.79×2.68 in
  • Weight: 595g / 20.98oz

What’s in the BoxTribit BTS25S Portable Wireless Speaker fig 1

Overview Buttons & IndicatorsTribit BTS25S Portable Wireless Speaker fig 2

  •  Power Button
  • Indicator
  •  Bluetooth Button
  •  MFB Taste
  • Volume-
  • Volume+
  • EQ Mode Button
  • Indicator
  • AUX-IN Port
  • Charging Port

ConnectionsTribit BTS25S Portable Wireless Speaker fig 3Bluetooth PairingTribit BTS25S Portable Wireless Speaker fig 4Stereo Mode

  • Make sure both speakers are on.
  •  Press * on one of the speakers to enter the pairing state.
  •  Press * on the other speaker for Ss, then release the button to enter Stereo pairing when you hear the “Stereo mode”. When you hear “Left chanel “on the left speaker and ” Right chanel ” on the right speaker, the ” Stereo mode” is on.
Function Button Operation
 

Power ON/OFF

 

Power Button

Press t he button to turn on / off the speaker
 

Pair a Bluetooth

Device

 

Bluetooth Button

Press the button to manually enter pairing mode
 

Volume Up

 

Volume +

Press the button to increase the volume level
 

Volume Down

 

Volume-

Press the button to decrease the volume level
 

Ploy/pause

 

MFB

Press once the button
 

Next track

 

MFB

Doub le press the button
 

Previous track

 

MFB

Press the button for 3 times
Answer/ end the incoming coll MFB Press once the button
Reject on incoming coll  

MFB

Press and hold the button for 2s
 

 

Voice dial function

 

 

MFB

Press and hold the button for 2s to  activate ( your device

must support this function)

 

EQMode

 

XBASE

Press the button to switch Music normal mode , Boss and Audiobook mode

Indicators

 

 

 

 

 

 

 

Power indicator

Blue indicator flashes quickly Bluetooth pairing mode
Blue indicator keeps sturdily on  

Connected

 

 

The red light is always on

Charging/ battery <15% battery<2% prompts automatic shutdown
 

Greenlight is always o

 

Battery full

 

Power display

 

Mobile phone display

 

 

 

 

EQ Mode indicator

 

White indicator lights up

 

Bass Mode

 

Green indicator lights up

 

Audiobook Mode

 

Lights off

 

Normal Music Mode

Reset

If this speaker has any problem, you can try to press and hold Volume + and Volume – buttons simultaneously for 5s to reset this speaker and remove the old pairing in your Bluetooth device, and then pair again.

Customer Service

IC Caution

This device contains a Science-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic DevelopmentCanada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

  • This device may not cause interference.
  • This device must accept any interference, including interference that may cause undesired operation of the device.

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 75 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio / TV technician for help.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

  • This device may not cause harmful interference.
  • This device must accept any interference received, including interference that may cause undesired operation.

Documents / Resources

Tribit BTS25S Portable Wireless Speaker [pdf] User Manual
BTS25S, 2ALNA-BTS25S, 2ALNABTS25S, BTS25S Portable Wireless Speaker, BTS25S, Portable Wireless Speaker

Leave a comment

Your email address will not be published.