HelloBaby AC

HelloBaby Baby Monitor Charger Instruction Manual

For Models HB6550, HB6560, HB50-5V, and other 2022+ HelloBaby Monitors

1. Üzeriview

This official HelloBaby replacement charger is designed to provide reliable power to your compatible HelloBaby baby monitor and camera units. It serves as an ideal accessory for replacing a lost or damaged power cord adapter, ensuring continuous monitoring of your little one.

Temel Özellikler:

  • Geniş Uyumluluk: Specifically designed for HelloBaby baby monitors and cameras from 2022 and later versions, including HB6550, HB6550-2, HB6560, HB40, HB6339, HB6336, and HB6250.
  • Güç Özellikleri: Input: 100-240V, 50/60 Hz; Output: 5.0V, 1A.
  • Optimum Uzunluk: Features a 6.6ft (approximately 2 meters) cable, matching the original power cord length for flexible placement.
  • Güvenlik Sertifikalı: Equipped with charging safety certification to ensure safe operation.
HelloBaby baby monitor charger with a warning tag about strangulation hazard.

Figure 1: HelloBaby replacement charger with its attached warning tag. Always keep cords out of reach of children.

2. Kurulum Talimatları

Follow these steps to properly set up your HelloBaby replacement charger:

  1. Uyumluluğu Doğrulayın: Ensure your HelloBaby monitor model is listed as compatible (e.g., HB6550, HB6560, HB50-5V, HB40, HB6339, HB6336, HB6250). If unsure, refer to your monitor's manual or contact HelloBaby support.
  2. Connect to Monitor/Camera: Insert the small connector end of the charger cable into the designated power port on your HelloBaby baby monitor or camera unit.
  3. Güç Çıkışına Bağlan: Plug the AC adapter end of the charger into a standard 100-240V wall outlet.
  4. Şarjı Onayla: The monitor or camera should indicate that it is receiving power or charging (e.g., a charging icon on the screen or an LED indicator).
Close-up of the power adapter showing input and output specifications: 100-240V, 50-60Hz, 0.2A input, and 5.0V, 1.0A output.

Figure 2: Power adapter details, confirming 5V 1A output for safe charging.

Video 1: This video demonstrates the HelloBaby monitor's features, including its setup and use, which involves connecting the power adapter for charging and continuous operation.

3. Operasyon

Once connected, the charger will automatically begin supplying power to your HelloBaby monitor or camera. For optimal battery life, it is recommended to keep the monitor plugged in when not in active use or when the battery level is low. The charger is designed for continuous use.

4. Bakım ve Onarım

To ensure the longevity and safe operation of your charger, please observe the following:

  • Dikkatli Kullanın: Avoid bending or twisting the cable excessively, especially near the connectors, to prevent internal wire damage.
  • Kuru Tutun: Do not expose the charger to water or excessive humidity.
  • Nazikçe Temizleyin: If cleaning is necessary, unplug the charger from the wall and wipe it with a dry, soft cloth. Do not use liquid cleaners.
  • Depolamak: Kullanılmadığı zaman şarj cihazını serin, kuru, doğrudan güneş ışığından ve aşırı sıcaklıklardan uzak bir yerde saklayın.
  • Güvenlik Uyarısı: The charger cable includes a warning tag regarding strangulation hazards. Always keep the cord out of reach of children (more than 3 feet / 0.9 meters away). Do not remove this tag.

5. Sorun Giderme

If your monitor or camera is not charging, perform the following diagnostic steps:

  • Güç Çıkışını Kontrol Edin: Duvar prizinin çalışır durumda olup olmadığını başka bir cihaz takarak kontrol edin.
  • Bağlantıları Denetle: Verify that both ends of the charger are securely plugged into the monitor/camera and the wall outlet.
  • Swap Cords (if applicable): If you have two original power cords (e.g., one for the monitor, one for the camera), try swapping them between devices. If a device works with the swapped cord, then the original cord for that device may be faulty, and this replacement charger is needed.
  • Destek Ekibiyle İletişime Geçin: If the issue persists after these steps, contact HelloBaby customer support for further assistance or warranty claims.

6. Ürün Özellikleri

ÖzellikDetay
MarkaMerhaba Bebek
Model NumarasıAC
Bağlayıcı TürüAC
Uyumlu CihazlarHelloBaby Baby Monitors (HB6550, HB6550-2, HB6560, HB50, HB6339, HB6250, HB40, HB6336)
Giriş Voltage100-240V (AC)
Çıkış Hacmitage5.0V
Ampöfke1 Amps
Netage5 watt
Kablo Uzunluğu6.6 ft (yaklaşık 2 metre)
Özel ÖzellikKısa Devre Koruması
RenkBeyaz
Ürün Ağırlığı0.317 ons

7. Garanti Bilgileri

This HelloBaby replacement charger comes with a one-year warranty from the date of purchase. This warranty covers manufacturing defects and ensures the product functions as intended under normal use. Please retain your proof of purchase for any warranty claims.

8. Müşteri Desteği

For any questions, concerns, or technical assistance regarding your HelloBaby baby monitor charger, please contact HelloBaby customer support. You can typically find contact information on the HelloBaby official webÜrünü satın aldığınız site veya perakendeci aracılığıyla.

© 2026 HelloBaby. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.