Document

TOURATECH-LOGOTOURATECH CRF1100L Crash Bar

TOURATECH-CRF1100L-Crash-Bar-PRODUCT

We recommend having the accessory parts fitted by a specialist workshop

SYMBOLS

TOURATECH-CRF1100L-Crash-Bar-FIG-2

  • Caution
  • Note
  • Warning
  • Liquid
  • Torque
  • Template
  • 2 Persons
  • Original motorcycle part

TOURATECH-CRF1100L-Crash-Bar-FIG-1

INSTRUCTION

  • These instructions are written based on our current state of knowledge. Information is provided without any guarantee as to its accuracy. Subject to technical modifications.
  • The order of assembly steps must be followed.
  • Touratech accepts no liability for incorrectly fitted parts and resulting material damage or personal injury!
  • Please observe applicable road vehicle (construction and use) regulations as well as
  • EC/ECE Directives and applicable laws in your country. If parts are fitted which require inspection and/or approval after fitting, take your vehicle to a testing station immediately and have the vehicle papers updated.
  • Check and if necessary tighten all bolted connections after 50 km.
  • Standard tightening torques in Nm for bolted connections with strength class 8.8.
  • For special tightening torques refer to your specialist workshop!
  • Please take into account that fitting panniers, crash bars, foot peg lowering kits (rider and pillion), Kickstand enlargement plate, front spoilers, and engine guards may restrict the bike’s lean angle!
  • If modifications are made to the fairing, stem, handlebar, fairing parts, etc., ensure that electrical wiring, brake lines, accelerator, and clutch cables are refitted correctly. Check clearance, on both sides with a full steering lock.
  • Always disconnect the battery when working on the electrics!
  • We recommend cutting protective film to size and applying it to impact areas that are likely to be chipped by stones.
  • Work on the brake system and suspension should always be carried out by a specialist workshop.
  • The maximum load on luggage racks is 5 kg! Luggage racks Zega Pro TC is 10 kg!
  • If other original accessories or aftermarket accessories are used, ensure clearance, and fitment, and do not come into contact with other parts!
  • Apply conventional lubricant to stainless steel bolts prior to assembly.
  • PDF fitting instructions also can be downloaded from the Touratech webshop

MOUNTING INSTRUCTION

TOURATECH-CRF1100L-Crash-Bar-FIG-3

Documents / Resources

TOURATECH CRF1100L Crash Bar [pdf] Instructions
CRF1100L Crash Bar, CRF1100L, Crash Bar
TOURATECH CRF1100L Crash Bar [pdf] Instruction Manual
CRF1100L Crash Bar, CRF1100L, Crash Bar
TOURATECH CRF1100L Crash Bar [pdf] Instructions
CRF1100L Crash Bar, CRF1100L, Crash Bar

Leave a comment

Your email address will not be published.