ThermoWorks LOGO

DishTemp® & DishTemp® Blue Battery Installation Instructions

Remove the battery cover by undoing the three retaining screws and lifting off.
Place the CR2032, 3-volt battery positive-side up, under the plastic and metal tab at the top of the battery compartment, and press down.

ThermoWorks CR2032 DishTemp Blue Battery -fig

Gently slide the battery so it is centered in the battery compartment.
The battery will stay in place without the battery cover when installed properly.
Replace the battery cover and tighten screws. Be careful not to overtighten.

ThermoWorks CR2032 DishTemp Blue Battery -fig

thermoworks.com
801-756-7705
[email protected]

Leave a comment

Your email address will not be published.