THERMALRIGHT FROZEN EDGE High Performance PWM Fan User Manual

Waterblock/Fan Guide

  • Connect PUMP power cable to motherboard WATER PUMP or CPU OPT socket Connect fan power cable to FAN HUB, then connect FAN HUB to CPU FAN socket on motherboard
    Waterblock RGB lighting can be control by motherboard by connecting lighting cable to 3-pin ARGB socket on motherboard.
    Waterblock LOGO plate can be rotated.

Fan&Radiator Mounting

Use long fan mounting screws to install fans on the radiator.

Please adjust the fan exhaust side according to your case airflow config.

Use short radiator mounting screws to install radiator to the case.

AMD AM4 AM5 Installation’

  • Remove factory CPU brackets and screws, KEEP the backplate.
  • Install four AM4/AM5 standoffs on backplate.
  • secure two AM4/AM5 brackets with four AM4/AM5 screws.
  • Apply thermal compound on CPU IHS.
  • Secure waterblock on CPU with two nuts on waterblock bracket.

INTEL LGA20XX Installation

  • Install four Intel LGA20XX screws on motherboard ILM
  • Install two Intel brackets on LGA20XX screws, secure them with nuts.
  • LGA20XX mounting hole on Intel brackets.
  • Apply thermal compound on CPU IHS.
  • Secure waterblock on CPU with two nuts on waterblock bracket

INTEL LGA1700 Installation

  • Install assembled Intel backplate from back side of motherboard
  • Install four 17XX standoffs through backplate screws from front side of motherboard
  • Install two Intel brackets on standoffs, secure brackets with four nuts.
  • Apply thermal compound on CPU IHS.
  • Secure waterblock on CPU with two nuts on waterblock bracket

INTEL LGA115X/1200 Installation

  • Install assembled Intel backplate from back side of motherboard.
  • Install four 115X standoffs through backplate screws from front side of motherboard
  • Install two Intel brackets on standoffs, secure brackets with four nuts.
  • Apply thermal compound on CPU IHS.
  • Secure waterblock on CPU with two nuts on waterblock bracket

INTEL LGA 17XX Backplate Assemble

If your motherboard is a 1700 motherboard, please pull the plastic buckle to the 1700 slot, Refer to the figure on the left below;

If your motherboard is a 115X or 1200 motherboard, please pull the plastic buckle to the 115X slot, Refer to the figure on the right below.

115X/1200

1700

Components

A240X2 Fan 280X2 360X3
BINTEL Bracket X2CINTEL115X/1700 Backplate X1DAM4/AM5 Bracket X2
E115X Black Standoffs X4F1700 Blue Standoffs X4GLGA20XX Screw X4HINTEL nuts X4
IFan mounting screw 240X8 280X8 360X12JRadiator mounting screw 240X8 280X8 360X12KThermal Compound X1LFAN HUB X1MAM4/AM5 Screw X4NAM4/AM5 Red Standoffs X4

 

 

HAZA.RORA.DA.STA.POST.WEKAAAAAAA

 

 

Documents / Resources

THERMALRIGHT FROZEN EDGE High Performance PWM Fan [pdf] User Manual
FROZEN EDGE High Performance PWM Fan, FROZEN EDGE, High Performance PWM Fan, Performance PWM Fan, PWM Fan, Fan

References

Leave a comment

Your email address will not be published. Required fields are marked *