Origin Acoustics - Origin Acoustics
Installation Guide for ORIGIN models including: D50-8 Director In Ceiling Loud speaker, D50-8, Director In Ceiling Loud speaker, Ceiling Loud speaker, Loud speaker, speaker
Director D50 In-Ceiling Loudspeaker - Origin Acoustics
Director D53DT In-Ceiling Loudspeaker - Origin Acoustics
File Info : application/pdf, 2 Pages, 1.29MB
DocumentDocumentDIRECTOR COLLECTION DIRECTOR D50-8 LOUDSPEAKER · 5 1/4'' (133mm) Poly/Rubber Woofer · 1'' (25mm) Silk Pivoting Tweeter · Butyl Rubber X-WaveTM Surround · Tool-less Mounting Installation SPECIFICATIONS PRODUCT NAME Cutout Diameter Speaker Diameter Mounting Depth D50-8 5 7/8'' (150mm) 6 3/4'' (172mm) 3 1/2 (90mm) Grille Diameter Grille Depth 7 3/16'' (182mm) 3/16" (5mm) Cutout 5 7/8'' (150m1m49)mm Please visit docs.originacoustics.com or scan this QR code using your smart device for the most up to date safety information and use instructions for this product. *All warranties and warranty conditions are subject to change. Please refer to docs.originacoustics.com for the latest information. QUICK START GUIDE The Speaker will arrive securely in its Bayonet Ring. Scan the QR Code on the reverse of this page for full instructions for this product. REMOVAL OF SPEAKER FROM BAYONET RING A B OPEN POSITION SPEAKER INSTALLATION 1 OPEN POSITION: PULL THE METAL LOCK TAB AWAY from the Bayonet Ring, before removing loudspeaker from Bayonet Ring. With one hand on the ring & one hand on the speaker, ONE QUARTER TURN COUNTER-CLOCKWISE will release the Speaker from the Bayonet Ring. 2 3 PUSH Rails Inwards Push the Zip-ClipTM rails inwards, just enough from the top, so they fit through the ceiling hole opening, then INSERT THE BAYONET RING INTO THE CUT-OUT hole within the ceiling surface. PUSH Tabs AGAINST RAIL through Ceiling Hole Reach through and PLACE 2 FINGERS ON THE GROOVES of the Bayonet Zip-ClipTM to pull each Zip-ClipTM down the rail. PULL DOWN on all 4 Bayonet ZipClipsTM to lower them along the Bayonet rails. Lift Speaker 4 B5ayonTewtist Speaker 15o CLOCKWISE to LOCK Into Bayonet Ring Note: If the Bayonet Zip-ClipsTM need to be adjusted or removed, depress the metal tabs along the rail and push up. 6 CLOSED POSITION After connecting wires, insert the Speaker into the Bayonet Ring, with the METAL LOCK TAB LIFTED AWAY FROM THE RING. TWIST THE SPEAKER 15 O CLOCKWISE, until the indicators on both the Bayonet Ring & the Speaker are aligned. CLOSED POSITION: To finalize the installation, PUSH THE METAL LOCK TAB TOWARDS the Bayonet Ring. Note: Grille may not sit flush until this Lock is properly engaged. 11-30-23 6975 S Decatur Blvd, Las Vegas, NV 89118 · www.originacoustics.com · 844-674-4461 ©2023 Origin Acoustics. All copyrighted, trademarked and patented elements mentioned herein are the sole property of Origin Acoustics.