Zap specializes in commercial door automation systems and access control hardware, including heavy-duty jackshaft operators, motor control units, and security exit buttons.
แซ็ป is a diverse brand recognized primarily in the security and building automation sectors. It is widely known for Zap Controls (distributed by Action Industries), which manufactures advanced DC motor operators and control systems for commercial garage doors. The Zap Series 3 and 8800/8825 lines offer ultra-quiet, continuous-duty performance for sectional and rolling steel doors, featuring patented safety sensing technology and manual override capabilities.
In the realm of access control, Zap (often associated with System Q Ltd) produces a range of door entry peripherals, including 'Press to Exit' buttons and hygienic contactless exit devices. These products are designed for durability and ease of installation in secure environments. While the name Zap has historically been associated with other ventures such as electric vehicles (Zap Energy), the current product documentation predominantly covers industrial door automation and entry system components.
คู่มือล่าสุดจาก manuals+ คัดสรรมาเพื่อแบรนด์นี้
รับชมวิดีโอการตั้งค่า การติดตั้ง และการแก้ไขปัญหาสำหรับแบรนด์นี้
คำถามที่พบบ่อยเกี่ยวกับคู่มือ การลงทะเบียน และการสนับสนุนสำหรับแบรนด์นี้
To open the door manually, ensure the door is fully closed if possible. Pull the Manual Override Release Lever to disengage the drive, then lift the door manually. Press the lever down to re-engage the drive once power is restored.
If the door refuses to close, check the safety photo-electric sensors for alignment or obstruction. If the beam is blocked or misaligned, the door will not close automatically and may require 'Dead-Man' operation (holding the close button).
Most Zap exit buttons can be wired as Normally Open (NO) or Normally Closed (NC) depending on your access controller. For a fail-safe magnetic lock setup, the button is typically wired to break the circuit when pressed.
Regular maintenance is recommended every six months or 2500 cycles. Check the balance of the door manually, inspect the V-belt tension on the manual override lever, and verify that safety reversal sensors are functioning effectively.