TOGUARD CE18A Dash Camera User Manual
TOGUARD CE18A Dash Camera

Огоҳиҳои муҳим

  • This product is intended for using in motor vehicles only. Do NOT install the camera where it might block the driver’s view of road (including the mirrors) or the deployment of the airbag.
  • Before using this device, please insert the memory card first, and need to format micro SD card to FAT32 format on PC firstly, then format the memory card in camera menu.
  • This camera records video at high resolution. Be sure to use high speed Micro SD card (Class 10 or above). 16 GB or 32 GB Micro SD card is recommended.
  • safety reasons, this camera has a small built-in battery, which is used to save the video file after external power supply cuts off (car turns off).
  • Be sure the camera lens is clean and there is nothing blocking the lens.
  • DO NOT leave the camera in direct sunlight for a long period of time or where the temperature could go above 140°F(60°C).

Вазифаи интерфейс ва тугма

Вазифаи интерфейс ва тугма
Вазифаи интерфейс ва тугма

Функсияи тугма

  • ҳокимият
    • When the camera is off, press and hold power button to turn on the camera.
    • Under any mode, press and hold power button to turn off the camera.
    • When the camera is on, short press to turn on/off screen display.
  • Меню
    • In Video / Photo / Playback mode, short press to enter setup menu for that particular mode, short press again to access System Setup Menu.
    • During video recording, short press to manually lock/ unlock current video.
    • In Standby, press and hold to switch working mode.
  • Up
    • During video recording, short press to turn ON/OFF audio recording.
    • In setup menu, short press to select options and adjust values.
    • In Playback, short press to select files.
  • поён
    • In setup menu, short press to select options and adjust values.
    • In Playback, short press to select files.
    • In the recording state, short press the down button to switch the recording screen.
  • OK
    • In Video Mode. short press to start/stop recording.
    • In Photo Mode. short press to take a photo.
    • In Setup Menu, short press to confirm selection and changes.
    • In Playback Mode. short press to play a video file.
  • Reset
    • Short press to reset the camera to factory default status.

Set up and Installation

Set up and Installation

  1. Before installation, please check the camera’s normal function, and make sure you are using a high speed Micro SD card (speed Class 10 or above),and format the card in the camera menu before recording.
  2. Use the suction cup mount to install the CE18A dash cam on the windshield. The recommended place is near the rearview mirror facing front, adjust the lens angle for best coverage
  3. .Adjust the lens angle of the camera, make sure you get the best coverage over the hood and the road ahead, so you can record what happens.
  4. Connect the power to the camera and the cigarette lighter, hide the rest of the cable in the gap of the interior trim board.

Реҷаи корӣ

The CE18A operates in 3 modes: Video Recording Mode, Photo Mode and Playback Mode. These modes also have menu to help you configure recording and taking photos. Press and hold “Menu” to switch between different modes and access to the mode you want. Watch the icon on top left corner of the screen for each mode.

Ҳолати сабти видео

The camera will automatically enter Video Recording Mode and start recording when connected to a car charger and power on. A Red dot flashing on the top left corner indicates recording is in progress. Press the OK to stop recording, or start recording again.

In all 3 operating mode, you can press the Menu button once to access the menu settings for that particular mode, and press twice to display System Setting Menu. The System Setting Menu is common to all modes.

Press UP and DOWN to scroll through the various setting options and press OK to select and confirm selection, Press MENU again to exit the setting menu.

Ҳолати сабти видео

  1. Нишони Ҳолати Видео
  2. Статуси сабти давр
  3. Муайянсозии тасвир
  4. Нишондиҳандаи сабт
  5. Video Lock Status
  6. WDR Status
  7. G-Sensor Status
  8.  Дарозии сабт
  9. Видео Қатли падар
  10. Rear screen
  11. Статуси мониторинги таваққуфгоҳ
  12. Статуси корти хотира
  13. Ҳолати барқ
  14. Рақами сабти мошин
  15. Статуси сабти аудио
  16. Сана ва вақт

Video Recording Menu

Video Recording Menu

Ҳалнокӣ: Adjust recording video resolution, 1080P/ 720P/ VGA available. When connected to the rear camera, recording video resolution: 1080P+720P/720P+720P/VGA+VGA Loop Recording: This function allows you to set video length to 1/3/5minutes, select a value to activate loop recording, so when storage is full, it will automatically loop back to the earliest file and record over it.
WDR: Wide Dynamic Range: turn on to optimize video quality with wider light range and image details.
Муайян кардани тасвир: Turn ON/OFF motion detection function. In the video mode, in the standby state, when the front camera screen changes, the driving recorder will automatically record for 11 seconds .

Video Recording Menu
Сабти овоз:
Turn ON/OFF audio recording in video. Date Stamp : Enable/Disable the date and time marks in video files.
G-Sensor: G-sensor will detect significant or sudden shock and movement, then automatically locks current file from loop recording. Low/Medium/High sensitivity available.
Мониторинги таваққуфгоҳ: It’s used to protect your car after parking. With this function on, after you stop the car and the camera turns off, it stays standby. When camera detects collision, it will automatically turn on and take a short video, then shut down automatically.
Car Number: Turn on to stamp your car plate number in video.

Photo Taking Mode

The CE18A camera can operate in Photo Taking Mode, and take HD photo up to 12 Mega pixels.

Барои акс гирифтан:

Simply power on the CE18A camera. Press Mode to select Photo Mode, and press OK to take photo.
Like the Video Recording Mode, you can press the menu button once to access the setting menu for Photo Mode, press menu twice to enter system setting menu.

Photo Taking Mode

  1. Усули акс
  2. Анти Шэйк
  3. Қарори тасодуфӣ
  4. Photo Counts
  5. Статуси корти хотира
  6. Ҳолати барқ
  7. Date& Time

Photo Mode Menu

Қарори: Set the photo resolution, Up to 12MP available.
Анти Шэйк: Turn on to stabilize photo, reduce shaking.
Санаи Сентamp: Enable/Disable the date and time stamp in photo.

Усули бозсозӣ

Ин режим ба шумо имкон медиҳад, ки видеои сабтшударо боз кунед ё view хабарнигори.

  1. Stop video recording, press and hold Menu button twice to switch to Playback Mode.
  2. Тугмаи боло ва поёнро барои ҳаракат дар сабт истифода баред files/ photos -ро пахш кунед ва OK -ро пахш кунед view видеои сабтшуда.

Менюи бозикунӣ

After choosing a recorded video or photo, press the Menu button once to access the setting menu for Playback Mode.

Менюи бозикунӣ

Нобуд кардан: Ҷориро нест кунед file displayed or delete all files.
Ҳифзи: Lock/Unlock the current file displayed or Lock/ Unlock all files.
Слайд-шоу: Select a time gap to activate this function, and all recorded file will be displayed in slide show.

Менюи танзимоти система

Press MENU button twice to access System Setting Menu in any mode. The TOOL icon is highlighted in the upper left corner.

Менюи танзимоти система

Посбони сафҳа: Вақтро барои ба таври худкор хомӯш кардани экрани LCD пас аз амалиёт таъин кунед.
Худкори Ҳокимият: Set the time for the camera to automatically power off to save energy. After the camera is idle for set time, it will power off.
Фосила: Set light frequency to 50Hz or 60Hz, and press OK. Beep Sound: Turn on/off sounds when you press any buttons.

Менюи танзимоти система
Chinese/English/Japanese/Deutsh/French/ Italian/Spanish
Сана / вақт: Change the time and date by using the UP and DOWN button, then press OK to confirm.
формати: Format the Micro SD card.
Танзими пешфарз: Reset all settings back to factory default.
Version: Нусхаи нармафзорро санҷед.


намуна Toguard  CE18A
Барраси Санҷанда тасвир Санҷандаи баландсифати CMOS
Экрани 2.45 дюймли дисплейи LCD
линза 170°  High-Resolution Wide Angle Lens
Video  Resolution 1920*1080P+1280*720P/
Намуди видео MOV
Рамзгузории видео H.264
Picture  Format JPG
Photo  Resolution 12MP / 10MP / 8MP / 5MP /3MP/2MP/


Сабти Loop дастгирї
Power on recording дастгирї
WDR дастгирї
Бастани G-Sensor дастгирї
забон Chinese/English/Japanese/Deutsh/ French/Italian/Spanish
Сабти аудио Микрофони дарунсохт, Фаъол / хомӯш ихтиёрӣ
гардероб Micro SD Card (то 32GB)
USB интерфейси Mini USB
Низоми амал Windows 7/10 ё MAC
Қувваи дохилӣ Батареяи дарунсохташудаи Li-ion
Таъмини барқии беруна DC 5V / 1.5А
Ҳарорати нигоҳдорӣ -4 ° F ~ 140 ° F (-20 ° C ~ 60 ° C)
ҳарорати амалиётӣ 14°F~122°F(-10°C~50°C)

Мушкилоти умумӣ ва ҳалли онҳо

  • Q: Even though set the screen saver, but the screen will randomly.
    A: The power supply might not be stable, please change another car charger to try.
  • Q: Why dash cam drain car battery?
    A: Please check whether the cigarette lighter still be on after you turn off car engine.
  • Q: The camera keeps starting and off?
    A: That could be the parking monitor function being triggered, check the setup menu.
  • The dash cam will stop automatically while recording.
    1. A: Check whether the memory card is full.
    2. Check whether the Micro SD card is high-speed above C10.
    3. Корти хотираро санҷед, шояд видеои басташуда хеле зиёд бошад, ки сабти ҳалқа дуруст кор намекунад.
    4. Check the car charger connection status, if the connection is loose, the power supply is not stable, the camera will automatically turn off.
  • If the video played on the computer is somehow not fluent or jammed.
    • A: Try to play the video with other video players, like : Pot player or VLC player.
    • Корти Micro SD-и худро дар камера формат кунед.
    • Run speed test on the memory card to make sure the memory card fits the requirement: Write Speed is over 10MB/S.
  • Q: There are stripes interference in the image. There should be wrong light frequency.
    A: According to the local main frequency, make the appropriate settings 50HZ or 60HZ.
  • Suction mount cannot attach on windshield well?
    1. A: Please clean the windscreen where attaching with a glass cleaning wipe. Removed the protective film, If it does not work, warming your windscreen then try it again.
    2. Please soak suction mount to warm water for a moment.
    3. If it is still not working, we are glad to send a new suction mount to you, please contact us ([почтаи электронӣ ҳифз карда шудааст]) to get a replacement.
  • Q: Without external power supply, the camera only lasts very short time, or it just can’t turn on.
    A: The built-in battery is very small for safety reasons, not designed to work alone, so please keep it connected to external power supply.
  • Q: When connect the camera with PC by USB cable, it will show “Mass Storage” and “PC Camera”, I метавонадnot do any thing.
    A: In this situation, you can directly playback video on PC. If you want to operate camera, please connect it with cigarette lighter by car charger we provided.

Not having a positive experience?

Лутфан бо мо дар тамос шавед

[почтаи электронӣ ҳифз карда шудааст]

We will offer prompt and authoritative reply within 24 hours and try our best to resolve your problem ASAP. More Safe Guarantee with Toguard!


Ҳуҷҷатҳо / Сарчашмаҳо

TOGUARD CE18A Dash Camera [pdf] Дастури корбар
CE18A Dash Camera, CE18A, Dash Camera

Эзоҳ диҳед

Суроғаи почтаи электронии шумо нест, нашр карда мешавад.