TechLogix UNIV-SPLICE-005 Optical Fiber Mechanical Splice

Product View

Included Accessories

NOTE: 

1. The three splice applications above are supported.
2. 250µm fiber needs to use the build tubes.

NOTE: 

1. Strip about 30mm of the fiber down to 250µm (the medium hole on your stripper).
2. RE-STRIP the same fiber down to 125µm (the smallest hole on your stripper).
3. Clean the fiber after stripping with alcohol and cloth.

Dimenssions

NOTE: Place the fiber in the correct position as shown above, and the push the lock to fix the fiber.

NOTE: Cleave the 125µm fiber of 125µm 13mm and 9mm with a cleaver and check the length as shown above.

INSTRUCTIONS

Documents / Resources

TechLogix UNIV-SPLICE-005 Optical Fiber Mechanical Splice [pdf] User Guide UNIV-SPLICE-005 Optical Fiber Mechanical Splice, UNIV-SPLICE-005, Optical Fiber Mechanical Splice, Fiber Mechanical Splice, Mechanical Splice, Fiber Splice, Optical Fiber Splice

References

• User Manual