tangem ring Ring Size Finder
Product Information
Specifications
- Product Name: Ring Sizing Guide
- Material: Paper
- Dimensions: Standard A4 size
Product Usage Instructions
Print this page out at 100%. Do not scale the print.
Either measure this printed ruler against a real ruler to check the scale has printed correctly
Or place a coin on the corresponding circle and check
Printout Instructions
- Print this page out at 100% without scaling the print.
- Verify the scale by measuring the printed ruler against a real ruler.
Measurement Methods
Then choose of the following methods to determine your ring size
THE STRING METHOD:
- Use a non-stretchy thread and wrap it around the base of your finger.
- Mark the point where the thread overlaps with a pen.
- Compare the length of the string to the size chart provided to determine your ring size.
THE RING METHOD:
- Place an existing ring that fits on the sheet.
- Find the circle that matches the inside of your ring to determine your size.
THE CUT-OUT METHOD:
- Cut out this little paper tool below and slide Point B through slot A.
- Fit the sizer snugly around the base of your STinger ensuring you can take the sizer oFF over your knuckle.
FAQ
Q: Can I use any type of thread for the string method?
A: It is recommended to use a non-stretchy thread for accurate measurements.
Q: What if my measurement falls between two sizes on the chart?
A: It is advisable to choose the larger size for comfortable wearing.
Documents / Resources
 | tangem ring Ring Size Finder [pdf] Instructions Ring Size Finder, Size Finder, Finder |