Microsemi Manuals & User Guides

Microsemi SmartDesign MSS GPIO Configuration User Manual

March 25, 2023

Microsemi SmartDesign MSS GPIO Configuration The SmartFusion Microcontroller Subsystem (MSS) provides a GPIO hard peripheral (APB_1 sub bus) with 32 configurable GPIOs. The actual behavior of each GPIO (input, output and output enable register controls, interrupt modes, etc.) can be…

Brand: Microsemi

Microsemi SmartDesign MSS Firmware Configurator Owner’s Manual

March 25, 2023

Microsemi SmartDesign MSS Firmware Configurator Owner's Manual Firmware The SmartDesign MSS Configurator is a specialized SmartDesign for MSS configuration. If you are familiar with SmartDesign then the MSS Configurator will be very familiar. The MSS Configurator finds all the compatible…

Brand: Microsemi

Microsemi AC361 SmartFusion FPGA Fabric Synthesis Guidelines User Guide

March 25, 2023

Microsemi AC361 SmartFusion FPGA Fabric Synthesis Guidelines Introduction SmartFusion™ intelligent mixed signal FPGAs integrate an FPGA fabric, hard ARM® Cortex™-M3 processor, and programmable analog for a wide variety of embedded system applications. SmartFusion FPGAs contain a hard embedded microcontroller subsystem…

Brand: Microsemi

Microsemi AC359 SmartFusion cSoC Board Design Guidelines User Guide

March 25, 2023

Microsemi AC359 SmartFusion cSoC Board Design Guidelines Objective The successful design of printed circuit boards (PCBs) incorporating the SmartFusion® customizable system-on-chip (cSoC) devices requires a good understanding of the mixed signal nature of the SmartFusion chips. Good board design practices…

Brand: Microsemi

Microsemi SmartDesign MSS Real Time Counter (RTC) Configuration User Guide

March 24, 2023

Microsemi SmartDesign MSS Real Time Counter (RTC) Configuration Actel Corporation, Mountain View, CA 94043 © 2010 Actel Corporation. All rights reserved. Printed in the United States of America Part Number: 5-02-00244-0 Release: June 2010 No part of this document may…

Brand: Microsemi

Microsemi SmartDesign MSS I/O Editor User Guide

March 24, 2023

Microsemi SmartDesign MSS I/O Editor Changing I/O Bank Settings The SmartDesign MSS Configurator is a specialized SmartDesign for MSS configuration. If you are familiar with SmartDesign then the MSS Configurator will be very familiar. The I/O Editor is a specialized…

Brand: Microsemi

Microsemi SmartDesign MSS Embedded Nonvolatile Memory (eNVM) User Guide

March 24, 2023

Microsemi SmartDesign MSS Embedded Nonvolatile Memory (eNVM) Introduction The MSS Embedded Nonvolatile Memory (eNVM) configurator enables you to create various memory regions (clients) that need to be programmed in the SmartFusion device eNVM block(s). In this document we describe in…

Brand: Microsemi

Microsemi AC490 RTG4 FPGA: Building a Mi-V Processor Subsystem User Guide

March 24, 2023

Microsemi AC490 RTG4 FPGA: Building a Mi-V Processor Subsystem Revision History The revision history describes the changes that were implemented in the document. The changes are listed by revision, starting with the most current publication. Revision 3.0 The following is…

Brand: Microsemi

Microsemi UG0856 PolarFire FPGA Video Kit User Guide

March 23, 2023

Microsemi UG0856 PolarFire FPGA Video Kit Microsemi makes no warranty, representation, or guarantee regarding the information contained herein or the suitability of its products and services for any particular purpose, nor does Microsemi assume any liability whatsoever arising out of…

Brand: Microsemi

Microsemi A2F-EVAL-KIT-2 SmartFusion Evaluation Kit User Guide

March 23, 2023

SmartFusion Evaluation Kit Quickstart Card Kit Contents—A2F-EVAL-KIT-2 Quantity  Description 1 SmartFusion® Evaluation board with A2F200M3F-FGG484 2 USB 2.0 A to mini-B cable 1 Quickstart card The A2F-EVAL-KIT-2 is RoHS-compliant. Overview The Microsemi SmartFusion Evaluation Kit provides designers access to SmartFusion…

Brand: Microsemi