Installation Guide for Juniper models including: CV-4, CV-4 4-Person Open Meeting Pod, 4-Person Open Meeting Pod, Open Meeting Pod, Meeting Pod, Pod
4-Person Open Meeting Pod | Juniper Office Furniture
CV-4 4-Person Open Meeting Pod General Installation Guide 4-PERSON OPEN MEETING POD 1 | Measure to Approximate Width Measure 85" from outer edge of pod of 78.7" from inner wall of pod to find approximate width. Once positioned, roof panel may be installed. 85" 78.7" 2 | Secure Connecting Steel Dowels to Top Panel Insert connecting steel dowel plate into marking hole on bottom side of top panel and insert four 3/4" screws through flat plate to secure. Repeat step for all 10 steel dowels. ii 4-PERSON OPEN MEETING POD 3 | Connect Main Power Assemble connector joint by securing male and female halves together and secure with connector clips on top and bottom of assembly. 4 | Connect Power to Top Panel Assemble connector joint by securing male and female halves together and secure with connector clips on top and bottom of assembly. Once connected, tuck completed assembly into slot at top of side panel. iii 4-PERSON OPEN MEETING POD 5| Secure Top Panel Line up steel dowels so they are flush with joint holes on adjacent panel. Push against outer walls of pod until panels are flushed. 6 | Secure Legs to Table Secure 4 screws through pre-drilled holes of each table base and into bottom of table surface. iv END OF 4-PERSON OPEN MEETING POD SECTION 7 | Place Seats Inside Pod Tilt seat at a 45 degree angle. Slide into pod while tilting seat back so seat sits flat on floor. Repeat for other side. 8 | Place Table Inside Pod v 1-866-999-0955 | hello@juniperoffice.com | juniperoffice.com © 2023 Juniper Office | Version 23.0.0Adobe PDF Library 17.0 Adobe InDesign 19.0 (Macintosh)