HVS230COB10 LED Strip
“
Specifications
- Product Name: LED Strip HVS230COB10
- Model: HVSCOBLEDSTRIP
- IP Rating: IP65
Product Usage Instructions
Safety Precautions
1. All handling with the luminaire must be carried out only when
the luminaire is disconnected from the mains.
Installation
1. Ensure that the LED strip is securely mounted in the desired
location.
2. Seal the joints and ends of the strip with silicone to
maintain the IP65 rating.
End Cap Attachment
1. Attach the end caps securely to both ends of the LED
strip.
2. For multiple end caps, repeat the attachment process for each
cap.
Maintenance
1. Regularly check the sealant on joints and ends to ensure the
IP65 rating is maintained.
2. Clean the LED strip gently with a soft, dry cloth to remove
dust or dirt buildup.
FAQ
Q: What should I do to maintain the IP65 rating of the LED
strip?
A: Ensure that the joints and ends of the strip are sealed
properly, for example, with silicone.
Q: How should I clean the LED strip?
A: Use a soft, dry cloth to gently wipe off any dust or dirt
accumulated on the strip.
“`
EN CZ
LED STRIP HVS230COB10
HVSCOBLEDSTRIP
! WARNING / UPOZORNNÍ
EN Installation can be carried out by a qualified person only DE Montage darf nur qualifizierte Person durchführen CZ Instalaci smí provádt pouze odborn zpsobilá osoba SK Montáz môze vykonáva iba kvalifikovaná osoba HU A szerelést megfelel szakképzettséggel rendelkez személynek kell végeznie PL Montau dokonywa moe tylko wykwalifikowana osoba
OFF OFF/VYPNOUT
EN All handling with the luminaire must be carried out only when the luminaire is disconnected from the mains.
CZ Veskerou manipulaci se svítidlem provádt pouze pi odpojeném napájení ze sít.
IP65
WARNING / UPOZORNNÍ
EN The LED strip meets the IP65 rating, except for the joints and ends of the strip, which need to be sealed, for example with silicone.
CZ LED pásek spluje krytí IP65 krom spoj a konc LED pásku, které je nutné osetit napíklad silikonem.
Dlitelnost kazdých 100mm
Pímá spojka
Ukoncení LED pásku pomocí koncovky
—
–
+
+
1 EN Slide onto the contacts of the LED strip, ensuring correct polarity (+ and ).
CZ Nasute na kontakty na LED pásku a dodrzujte polaritu (+ a -).
2 EN Attach the end caps. CZ Nasate krytky.
Napájecí kabel / Spojka s kabelem
Pímé 230V napájení
3 EN Press the end caps firmly into place. CZ Krytky pecliv domácknte.
–
–
+
+
1 EN Slide onto the contacts of the LED strip, ensuring correct polarity (+ and ).
CZ Nasute na kontakty na LED pásku a dodrzujte polaritu (+ a -).
2 EN Attach the end cap. CZ Nasate krytku.
3 EN Press the end cap firmly into place. CZ Krytku pecliv domácknte.
www.t-led.cz
T-LED s.r.o.
Zitná 610/23, 110 00 Prague Czech Republic
Documents / Resources
 | T-LED HVS230COB10 LED Strip [pdf] Instruction Manual HVS230COB10 LED Strip, HVS230COB10, LED Strip, Strip |