Carlson Pet Gate Model 0937 PW: Installation and Use

Important Safety Information

Read all instructions before assembly and use. Failure to follow these instructions could result in serious injury or death. Always ensure the gate is securely installed.

• This gate is intended for use with children and pets.
• Never use without all hardware attached and properly tightened.
• Do not use if any parts are missing or damaged.
• Ensure the gate is installed on a stable and level surface.
• Keep small parts away from children during assembly.

Package Contents

Verify you have all parts before beginning installation:

• Gate Panel
• Top and Bottom Rails
• Mounting Hardware (screws, wall anchors)
• Locking Nuts
• Spanner Wrench
• Instruction Manual

Installation Instructions

Step 1: Prepare the Opening

Measure the opening where the gate will be installed. Ensure it is within the specified width range for this model.

Step 2: Attach Rails

Attach the top and bottom rails to the gate panel using the provided hardware. Ensure they are securely fastened.

Step 3: Position the Gate

Place the assembled gate in the desired opening. Ensure it is level and stable.

Step 4: Secure the Gate

Use the provided mounting hardware to secure the gate to the wall. If mounting to drywall, use the included wall anchors. If mounting to a solid surface, pre-drilling may be required.

Note: Use the spanner wrench to tighten the locking nuts securely.

Step 5: Adjust Tension

Adjust the tension of the gate by tightening or loosening the mounting hardware until the gate is stable and operates smoothly.

Step 6: Install Pet Door (Optional)

If your model includes a small pet door, follow the specific instructions for its installation and operation.

Operation

• Opening the Gate: Squeeze and lift the handle to release the latch, then swing the gate open.
• Closing the Gate: Swing the gate closed until it latches automatically.
• Using the Pet Door: Operate the pet door latch to allow or restrict pet access.

Care and Maintenance

• Clean the gate with a mild soap and water solution.
• Do not use abrasive cleaners, as they may damage the finish.
• Periodically check all hardware to ensure it remains tight and secure.

Troubleshooting

Gate does not latch: Ensure the gate is properly aligned and the mounting hardware is tight. Check that the latch mechanism is clean and free of debris.

Gate is wobbly: Tighten all mounting hardware and locking nuts. Ensure wall anchors are securely in place if used.

Contact Information

For questions or assistance, please contact Carlson Pet customer support.