strands logo

MANUAL
SIBERIA DR 32″ LED BAR

strands SIBERIA DR 32 LED BAR

RED = + POSITIVE
BLACK = – TO CHASSIS GROUND
YELLOW = AMBER POSITION LIGHT
WHITE = – WHITE POSITION LIGHT

READ THIS BEFORE INSTALLATION
READ ALL INSTRUCTIONS AND STUDY DIAGRAMS BEFORE INSTALLING YOUR NEW LIGHTS!
LEGAL MOUNTING
Check with state or local authorities for laws governing usage and proper mounting of your new lights.
TAKE CARE OF YOUR PRODUCT
Keep the product clean. Dirt on the lens and heat sink may shorten the product’s lifetime.
We recommend using lukewarm water and alkaline degreasing.
Follow the degreasing instructions carefully and rinse off gently with cold or lukewarm water at low pressure.
WARNING!
Strong chemicals should not be used on the product. If you accidentally get strong chemicals on the product, rinse off immediately, use plenty of water so that no chemicals remain in any joint.
Some chemicals have a small amount of solvent in them, this can dissolve sealing adhesives and compromise the product’s waterproofness.
Some chemicals pull out liquid from plastic and rubber-based components, which makes the plastic or rubber brittle and bursts more easily.
Be careful not to use high water pressure close up on the product.
If you use high water pressure at short distances, most products find it difficult to close out the water.

INSTALLATION

If there is a contact/connector on the product, it should not be cut. If the connector is cut, the warranty is not valid.
If the product has a loose cable and no connector. If the cable is shorter than 50 cm, the cable must not be cut. If the cable is cut, the warranty is not valid.
If the cable is longer than 50 cm, it is ok to shorten the cable but not shorter than 50 cm.
If the cable is cut shorter than 50 cm, the warranty is not valid.
Tighten screws and bolts so that they do not loosen or chafe.
Do not tighten screws so hard that the protective bearings on the product break.
WARNING!
Do not use higher volts than the product description states.
This light becomes hot under continuous use. Don´t remove or touch the casing for at least 30 minutes after turning the lamp off.
Part no. 809182

Contact us if you need support: [email protected] or +46(0)320-450450
logoi 20www.strands.se
www.strandseurope.com

Documents / Resources

strands SIBERIA DR 32" LED BAR [pdf] User Manual
SIBERIA DR 32 LED BAR

References

Leave a comment

Your email address will not be published.