Starmax Technology GTL2 Smart Watch
Introduction
Product Overview
Crown Controls
Screen Controls
- Swipe down: Shortcut menu
- Swipe right: App board
- Swipe left: Menu
- Swipe up: Message notification
Charging and Power On
- Charge your watch: Align the charger correctly with the watch’s charging port;
- Power on: Charge for 5 minutes, or press the crown for 3 seconds to power on the watch.
Notes:
Use a power adapter or output with a specified voltage of 5V to avoid damage to the watch.
App Download and Connection
Download the Runmefit App
- Get “Runmefit” from the App Store or Google Play.
- Or scan the QR code on the right.
Connect the Watch with Your Phone
- Please make sure to always connect your watch through the Runmefit App. DO NOT directly connect it through the phone system Bluetooth.
- Co to “Device” > “Add device” in the Runmefit app, and choose your watch name to connect.
- Or go to ‘Settings” > “Connect to phone” on your watch, and scan the QR Code through Runmefit to connect.
How to Wear the Device?
- Wear the watch with the sensor side touching your skin;
- Leave a finger’s width between the edge of the watch and your wrist.
Bluetooth Calling
- This product has an IP68 waterproof rating, only suitable for daily water resistance, such as light rain, splashing water, and hand washing.
- Do not wear it for swimming, diving, hot showers, saunas, or other water sports.
- Avoid high-temperature environments to prevent damage.
- Please note this product is not a medical device. All data and measurements are for reference purposes only and should not be used for medical diagnosis.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Scan for User Manual
Scan for Help Center
Cot more questions? Co to help.runmefit.com/hc/en-us
FAQ
Why can’t I find or connect my device through the App?
- Check if your device is paired with the phone’s Bluetooth system;
- If so, find it in your phone’s “Settings” > “Bluetooth”, select “Forget this device”, then re-pair it via the Runmefit App.
- For iOS users: You need to accept the Bluetooth pairing request for successful pairing when the prompt pops up.
Why can’t my watch charge?
- Make sure the positive and negative poles of the charger are correctly aligned with the watch’s charging area.
- Check if the charger is connected to a power source and turned on.
- If the watch’s battery is extremely low, please allow time for initial pre-charging before normal charging begins.
Documents / Resources
 |
Starmax Technology GTL2 Smart Watch [pdf] User Guide 2ASAU-X03GTL2, 2ASAUX03GTL2, x03gtl2, GTL2 Smart Watch, GTL2, Smart Watch, Watch |