Хонеивелл логоThor VM1A Vehicle Mounted Computer
Упутство за 

Изван кутије

Уверите се да ваша кутија за отпрему садржи следеће ставке:

  • Thor VM1A vehicle-mounted computer (Model VM1A-LON)
  • Regulatory Sheet If you ordered additional accessories for your computer, verify that they are also included with the order. Be sure to keep the original packaging in case you need to return the computer for service.

Цомпутер Феатурес

 

Honeywell Thor VM1A Vehicle Mounted ComputerHoneywell Thor VM1A Vehicle Mounted Computer - Fig

Доцк Феатурес

Honeywell Thor VM1A Vehicle Mounted Computer - Fig 1

Стандардно пристаниште

Honeywell Thor VM1A Vehicle Mounted Computer - Fig 2

Enhanced Dock

 

Honeywell Thor VM1A Vehicle Mounted Computer - Fig 3

Mount to Vehicle
The Thor VM1A should be secured to an area in the vehicle where it:

  • Does not obstruct the driver’s vision or safe vehicle operation.
  • Will be protected from rain or inclement weather.
  • Will be protected from extremely high concentrations of dust or wind-blown debris.
  •  Can be easily accessed by a user seated in the driver’s seat while the vehicle is not in operation. To mount the VM1A using a RAM mount system:
  1. Attach RAM base to a vehicle (RAM ball, RAM Clamp, RAM Plate, etc.)
    Honeywell Thor VM1A Vehicle Mounted Computer - Fig 4
  2. Attach RAM ball to the Smart Dock
    Honeywell Thor VM1A Vehicle Mounted Computer - Fig 5
  3. Attach VM1A assembly to RAM base using RAM arm and tighten knob on RAM arm.

Honeywell Thor VM1A Vehicle Mounted Computer - Fig 6

  • For more mounting details, refer to the user guide available at спс.хонеивелл.цом.
    Connecting the Power Cable for 12-48 VDC Vehicles (10-60 VDC Direct Connection)
    Белешка: Refer to the Thor VM1A User Guide for other power connections, available at спс.хонеивелл.цом.
    Caution: For installation by trained service personnel only.
    Warning: Fuse Requirements For proper and safe installation, the input power cable must be connected to a fused circuit on the vehicle. If the supply connection is made directly to the battery, the fuse should be installed in the positive lead within 5 inches of the battery’s positive (+) terminal. The fused circuit requires a maximum time delay (slow blow) fuse with a current rating as noted below.
  •  За улаз од 12ВДЦ, користите 10А осигурач са спорим изгарањем који има ДЦ волtage rating greater than 12VDC
  • За улаз од 24ВДЦ, користите 6А осигурач са спорим изгарањем који има ДЦ волtage rating greater than 24VDC.
  • За улаз од 36ВДЦ, користите 4А осигурач са спорим изгарањем који има ДЦ волtage rating greater than 36VDC
  • За улаз од 48ВДЦ, користите 3А осигурач са спорим изгарањем који има ДЦ волtage rating greater than 48VDC.
    Белешка: For North America, a UL Listed fuse must be used.

Усмеравање каблова за напајањеHoneywell Thor VM1A Vehicle Mounted Computer - Fig 7

Схема ожичења кабла за напајање са правим углом и 6 жица
Honeywell Thor VM1A Vehicle Mounted Computer - Fig 8Окрените црвену и црвену/белу жицу заједно и увијте црну и црно/белу жицу заједно пре него што је повежете на напајање возила.
Connect the green wire to the vehicle ground:
Опрез: For battery-powered vehicles, the green wire must be connected to the vehicle chassis ground.
Опрез:  For internal combustion engine-powered vehicles, the green wire is connected to the vehicle chassis ground, which can also be battery negative.

Боја жице веза
црвен ДЦ + (10-60 ВДЦ)
Црвено бели ДЦ + (10-60 ВДЦ)
црн ДЦ -
Блацк / Бела ДЦ -
зелен Основа
блуе Улаз за сензор паљења (опционално)
Refer to the Thor VM1A User Guide, available at спс.хонеивелл.цом, За
further information about ignition control.

Директно напајање возила 10-60 ВДЦ

  1. The VM1A must not be mounted in the dock. The power switch on the dock must be turned Off. The power cable must be UNPLUGGED from the dock.
  2. While observing the Fuse Requirements, connect the power cable as close as possible to the actual battery terminals of the vehicle(if using unswitched power).
  3. Use proper electrical and mechanical fastening means for terminating the cable. Properly sized “crimp” type electrical terminals are an accepted method of termination. Select electrical connectors sized for use with 20AWG (0.81mm2) conductors.
  4. За боје и везе жица погледајте следеће дијаграме ожичења:
    • Ignition Control Wiring Diagram If switched vehicle power is available, the ignition wire can be connected. The VM1A will boot up when the vehicle ignition is turned on. Honeywell Thor VM1A Vehicle Mounted Computer - Fig 9• Аутоматско укључивање и ручно управљање Шема ожичења Жицу за паљење морате оставити искључену.
    Honeywell Thor VM1A Vehicle Mounted Computer - Fig 10Опрез: For battery-powered vehicles: Red and red/white wire twisted together to battery positive. Black and black/white wire twisted together to battery negative. The green wire connected to the vehicle chassis ground.
    Опрез: For internal combustion engine powered vehicles: Red and red/white wire twisted together to battery positive. Black and black/white wire twisted together to battery negative.  The green wire connected to the vehicle chassis ground can also be battery negative
  5. Route the cable the shortest way possible removing any leftover cable, and making sure the cable does not interfere with the safe operation and maintenance of the vehicle. The cable is rated for a maximum temperature of 221°F (105°C). The cable should be protected from surfaces that exceed this temperature, from physical damage from moving parts, and from chemicals or oil that cause the insulation to deteriorate. Avoid sharp bends. The power cable is less flexible in low-temperature environments
  6. Secure the cable to the vehicle structure at approximately one-foot intervals, taking care not to over-tighten, pinch conductors, or penetrate the insulation
  7. Connect the watertight connector end of the power cable to the dock power connector by aligning the connector pins to the power connector; push down on the watertight connector and twist it to fasten securely
  8. Secure the power cable to the VM1A using the strain relief cable clamps.
  9. Place VM1A in the dock
  10. If using the Screen Blanking feature, install the screen blanking box or switch. (Refer to the Thor VM1A User Guide, available at sps.honeywell.com, за додатне информације о оквиру за затамњивање екрана.)
  11. Press the power switch on the back of the dock
  12. Press the power button on the front of the VM1A
  13. Configure the Auto-ON behavior.

Поново покрените рачунар

Можда ћете морати да поново покренете рачунар да бисте исправили услове у којима апликација престаје да реагује на систем или се чини да је рачунар закључан.

  1. Притисните и држите дугме за напајање док се не појави мени са опцијама.
  2. Изаберите Рестарт.
    Да бисте поново покренули рачунар ако екран осетљив на додир не реагује:
    • Притисните и држите дугме за напајање око 8 секунди док се рачунар поново не покрене.

Белешка: Да бисте сазнали више о напредним опцијама ресетовања, погледајте водич за кориснике.

подршка

Го то спс.хонеивелл.цом and select Support to search our knowledge base for a solution or to log into the Technical Support portal.
Корисничка документација
За упутство за употребу и осталу документацију идите на спс.хонеивелл.цом.
Ограничена гаранција
Информације о гаранцији потражите на спс.хонеивелл.цом and select Support > Warranties.
Патенти
За информације о патентима погледајте ввв.хсмпатс.цом.
Жигови
Андроид је заштитни знак компаније Гоогле ЛЛЦ.
одрицање
Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made. The information in this publication does not represent a commitment on the part of HII. HII shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use of this material. HII disclaims all responsibility for the selection and use of software and/or hardware to achieve intended results. This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated into another language without the prior written consent of HII. Copyright © 2021 Honeywell International Inc. All rights reserved

Документи / Ресурси

Honeywell Thor- VM1A Vehicle-Mounted Computer [пдф] Упутство за употребу
Thor-VM1A Vehicle-Mounted Computer, Vehicle-Mounted Computer, Mounted Computer

Ostavite komentar

Ваша емаил адреса неће бити објављена.