Document

speedlink SL-870200-GY True Wireless In-Ear Headphones User Guide
speedlink SL-870200-GY True Wireless In-Ear Headphones

GET STARTED

Product OverviewProduct Overview

INITIAL PAIRING:

Take the headphones out of their charging case and select „Speedlink VIVAS Headphones” on the device you would like to connect. A tone will indicate successful pairing.

PAIRING TO A RECENTLY CONNECTED DEVICE:

The headphones will automatically pair with the most recently connected device when taken out of their charging case.

OPERATION:

Each of the following functions can be performed by tapping/ pressing and holding the touch sensor of the respective headphone.

On/off: The headphones will automatically turn on when taken out of their charging case and turn off when put back inside. Each headphone can also be turned on by pressing and holding the headphone for three seconds or turned off by pressing and holding the headphone for five seconds.

Volume down: Triple tap the left headphone.

Volume up: Triple tap the right headphone.

Play/pause: Tap either headphone.

Answer/end call: Tap either headphone.

Previous track: Double tap the left headphone.

Next track: Double tap the right headphone.

Voice assistant: Press and hold both headphones until a tone can be heard.

CHARGING:

To charge the headphones, place them into their charging case.
While charging the LEDs of the headphones will light up red. Once the headphones are fully charged, the LEDs will light up blue and then turn off.

To charge the charging case, connect it to a power source using the charging cable provided. The charging process is indicated by the LED flashing. Once the case is fully charged, the LED will remain lit.

Technical support: www.speedlink.com

Safety instructions: www.speedlink.com

Disposal icon WEEE: Dispose the product at a recycling point. Do not dispose together with household waste. Incorrect storage/ disposal can harm the environment and/or cause injury.

Speedlink declares that this product complies with the directives listed in the section ‘Conformity notice’.

INTENDED USE

This product is intended to be used as in-ear headphones for connecting to tablets, mobile phones and other audio sources.
Do not use near water. Clean with a dry cloth. It contains no user-serviceable parts. Do not disassemble it and stop using it immediately if damaged. Speedlink GmbH accepts no liability whatsoever for any damage to this product or injuries caused due to careless or improper use or for purposes for which it is not intended.

Please keep this information for later reference.

SAFETY INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS

Warning icon Please note that the failure to observe these instructions can cause product damage, explosion, fire and/or electric shocks!

  • Only use the devices as indicated in the user guide.
    Do not open or repair them.
  • Do not expose the devices to liquids, heat or cold.
  • Do not use the devices in a damp environment.
    Clean the devices with a dry cloth.
  • Keep the devices and all loose parts away from children, pets and unauthorized persons.
  • Only use the devices with the appropriate provided accessories/cables.
  • Disconnect cables from the devices if they will not be used for a long time. When disconnecting the cables, don’t pull on the cord but on the plug.
  • Don’t use cables in any way other than mentioned in the user guide; don’t bend, cut, extend, knot or step on them.
  • Do not insert any foreign objects into the openings of the devices.
  • If the devices are damaged in any way or get too hot, stop using them immediately.
  • Take caution when using devices that emit radio signals if you have a pacemaker or are dependent on other sensitive electronic life aids.

Safety instructions in further languages: www.speedlink.com.

WARNING SYMBOLS AND MARKINGS

Battery Disposal icon  Lithium polymer battery.
Further information: www.speedlink.com

Warning icon Avoiding hearing damage.
Further information: www.speedlink.com

CONFORMITY NOTICE

Operation of the device (the devices) may be affected by strong static, electrical or high-frequency fields (radio installations, mobile telephones, microwaves, electrostatic discharges). If this occurs, try increasing the distance from the devices causing the interference.

Conformity notice in further languages: www.speedlink.com.

CONFORMITY NOTICE

IMPORTER/MANUFACTURER:
Speedlink GmbH
Im Dorf 5
27404 Heeslingen
GERMANY

Phone: (+49) 4287 9244-0

PRODUCT DETAILS:
Product no.: SL-870200-GY
Type description: VIVAS
True Wireless In-Ear Headphones, grey

THE PRODUCT COMPLIES WITH THE FOLLOWING DIRECTIVES:
RED 2014/53/EU
RoHS 2011/65/EU

For a full declaration of conformity, the latest user guide or FAQ, please visit www.speedlink.com.

RF frequency range: 2.402GHz – 2.480GHz

RF power transmission: < +8dbm

Further information: www.speedlink.com

Icons
All rights reserved. Speedlink, the Speedlink word mark and the Speedlink swoosh are registered trademarks of Zeitfracht GmbH & Co. KGaA.
*Bluetooth is a registered trademark owned by Bluetooth SIG, Inc.
The Instagram logo is a registered trademark/service mark of Instagram LLC.
The Facebook logo is a registered trademark of Facebook Inc. The YouTube logo is a registered trademark of YouTube LLC. All trademarks are the property of their respective owner. Technical specifications are subject to change. Information contained herein is subject to change without prior notice. Speedlink GmbH shall not be made liable for any errors that may appear. Please keep this information for later reference.

Icon www.speedlink.com

Logo

Documents / Resources

speedlink SL-870200-GY True Wireless In-Ear Headphones [pdf] User Guide
SL-870200-GY, True Wireless In-Ear Headphones, SL-870200-GY True Wireless In-Ear Headphones, Wireless In-Ear Headphones, In-Ear Headphones, Headphones

References

Leave a comment

Your email address will not be published.