USER MANUAL

Soundpeats Truefree

Soundpeats Truefree

MANUFACTURER
Shenzhen SoundSOUL Information Technology Company Limited
Room 1308-1309, Building B, Huihai Square, Chuangye Road,
Longhua District, Shenzhen, China. 518109
support@soundpeatsaudio.com
www.soundpeatsaudio.com

Package Content

Package Content

Product Diagram

Product Diagram

Specifications

Specifications

Wearing

  1. Identify the left and right earbuds.
  2. Insert the earbuds into your ears and adjust to nd best angle with microphone downwards.
  3. Make sure the eartips seal the ear canals.
Wearing

Get Started
Mono Mode

  1. The earbud enters pairing mode directly with a voice prompt “power on” after being taken out from the charging case. White indicator flashes quickly for around 10s, then red and white indicators ash alternately with a voice prompt “pairing”.“SOUNDPEATS TrueFree L” or “SOUNDPEATS TrueFree R” would show up on theBluetooth list, hit it to connect.
  2. If you want to connect two earbuds separately with 2 devices nearby, please connect the left one to one device at first. In case it will connect to the right earbud automatically aer being taken out from the charging case.

Stereo Mode

Take out both earbuds from the charging case. The two earbuds will flash in white at first. Then the le indicator goes out, and right indicator ashes in red and white. Activate the Bluetooth in your device and hit “SOUNDPEATS TrueFree R” on the Bluetooth list.

Factory Reset
(Try the following steps if you fail building connection between two earbuds, or between earbuds and device)

  1. Clear the pairing record between the earbuds and all of your devices.
  2. Hold and press the MFB of both earbuds for 10 seconds when in charging status, the LED indicator will ash red for 3 times if resetting successfully.

Charge

  1. Please charge the earbuds at least once every 3 months when not in use for a long time.
  2. To ensure charging safety, please do not use any USB charging adapter with current over 5V 1A. Please do not use quick charger to charge the earbuds and charging case.
Charge

Note:

  1. If you don’t know which device the earbud has already connected, please turn it off, then press and hold the button for 5 seconds until red and white indicatorashes alternately to have the earbud enter pairing mode again.
  2. If pairing device is switched off or Bluetooth disconnected, the earbuds will stay in pairing mode for 5 minutes and then power off automatically.
  3. The earbuds can remember previously paired devices. They would automatically connect to the last device they have paired before after being taken out from the case.

Button Control

Button Control

LED Indicators

LED Indicators

Warranty

We warrant this device 12 MONTHS from date of the original purchase for manufacturer defects.
support@soundpeatsaudio.com
www.soundpeatsaudio.com
Please scan the QR code or search the link below for detailed PDF manual :
https://soundpeatsaudio.com/downloads/

downloads

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B English digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:

(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

Questions about your Manual ? Post in the comments!

Join the Conversation

1 Comment

  1. Soundpeats Truefree headphones. Can’t seem to get right to flash on or pair . . . although my phone will find both the right & left. Says “can’t communicate with Soundpeat truefree R)”. Pairing and sound from left is fine. Why no lights on R ear when on charger? Why can phone see the R ear but not connect? Tis a puzzlement.

Leave a comment

Your email address will not be published. Required fields are marked *