Soundpeats Q12HD

Model: Q12HD

Package Content

Package Content
Package Content

Product Diagram

Product Diagram






  1. Identify the left and right earpieces.
  2. Insert the earbuds into your ears, and adjust the ear fins to find best angle until they fit flush in your ears and the ear tips seal In ear canal.

Get Started

  1. Activate the Bluetooth on your device.
  2. Power on the headphones and wait until the LED indicator flashes In blue and red.
  3. Tap “SOUNDPEATS 912 HD” on the Bluetooth list.

Mulfipoint Pairing

  1. Pair the headphones to first device.
  2. Deactivate the Bluetooth on first device.
  3. Pelt the headphones to second device.
  4. Activate the Bluetooth on first device and connect to the headphones.

Press and hold the MFB for 3s while charging. The LED Indicator will flash blue twice.


  1. Connect the charging port with any USB charging adopter or USB port evadable. Charging starts with LED indicator turning red and ends with it turning blue.
  2. When charging with a USE adapter, the charging current should not be great-er than 1A.Please do not use any quick charger to charge the headphones.

warrant this device 12 MONTHS from date of the original purchase for manufac-turer defects.
Please scan the OR code or search the link below for detailed PDF manual.

QR Code

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device. pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful Interference to radio communications. However, there Is no guarantee that interference will not occur ‘n a particular installation. If this equipment does cause harmful Interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the Interference by one or more of the following measures, — Reorient or relocate the receiving antenna. — Increase the separation between the equipment and receiver. — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/N technician for help.
This device complies with part 15 of the FCC Rules. Operation Is subject to the following two condffions (1) This device may not cause harmful Interference, and (2) this device must accept any interference received. including Interference that may cause undesired operation.

Questions about your Manual ? Post in the comments!

Leave a comment

Your email address will not be published. Required fields are marked *