SOUND AROUND PPHP1599WU Wireless Handheld Microphone
Specifications
- Microphone parameter
- Product name microphone
- Product frequency 600.85MHz-606.02MHz
- Operating voltage DC ：3V（5# 1.5V*2)
- Working current >1 10mA
- Dynamic range >105dB
- Frequency response 20Hz- 18KHz
- Signal-to-noise ratio >98dB
- pickup Moving-coil type
- Frequency Maximum frequency offset±10 KHz
- Continuous service time About 6-8 hours
- Modulation mode FM
- Hardware version number V4 .2 20230320
- Software version number 0643 V8 . 1
operation instructions
- Unscrew the tailpipe and install 2 AA5 batteries (2x 1.5V). Note: the polarity of the battery should not be reversed
- Press the power button, the microphone display will light up, and the microphone will enter the standby state.
Then turn on the receiver and wait for the microphone to connect to the receiver. Turn off the microphone and press the power button again. - When the microphone is in use, the display flashes, indicating that the battery power is fast enough to support the normal operation of the microphone, and the battery must be replaced i time
(Warm tip: The microphone is not used for a long time, please take out the battery to avoid battery liquid leakage corrosion circuit board, causing damage)
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The device can be used in portable exposure condition without restriction.
Frequently Asked Questions
- Q: How do I change the frequency of the microphone?
A: To change the frequency, refer to the user manual for specific instructions on adjusting the frequency settings - Q: What type of batteries does the microphone use?
A: The microphone uses two 1.5V batteries. Make sure to replace them with new batteries of the same type when needed.
Documents / Resources
 | SOUND AROUND PPHP1599WU Wireless Handheld Microphone [pdf] Instructions PPHP1599WU, PPHP1599WU Wireless Handheld Microphone, Wireless Handheld Microphone, Handheld Microphone |