ZALMAN M3 Matx Mini Tower Computer Case
Precautions
- Read this manual carefully before installing.
- Check the product and components before installing. If you find any abnormality, contact the location where you purchased the product for a replacement or refund.
- Wear gloves to prevent accidents when installing the product.
- Severe damage may occur when mounting the system, so do not apply excessive force.
- Connecting the cable incorrectly may cause a fire due to a short circuit. Make sure to refer to the manual when connecting the cable.
- Be careful not to block the ventilation hole of the product when using the system.
- Avoid locations with direct sunlight, water, moisture, oil, and excessive dust. Store and use the product in a well-ventilated location.
- Do not wipe the surface of the product using chemicals. (organic solvents such as alcohol or acetone)
- Do not insert your hand or another object into the product during operation, as this may injure your hand or damage the object.
- Store and use the product out of children’s reach.
- Our company assumes no responsibility for any problem that occurs due to the use of the product for purposes other than its designated purposes and/or the carelessness of the consumer.
- The exterior design and specifications of the product are subject to change without prior notice to consumers for quality improvement.
Removing the side panels
Removing the front panel
Mounting the motherboard
Mounting the PSU
Mounting the PCI-E(VGA) card
Mounting the 3.5″ HDD
Mounting the 2.5″ SSD / HDD
Mounting the radiator
Fans Included / Specifications
Specifications
| Model | M3 | |
| Case Form Factor | mATX Mini Tower | |
| Dimensions | 407(D) x 210(W) x 457(H)mm | |
| Weight | 6.0kg | |
| Case Materials | Plastic, Steel, Tempered Glass | |
| Motherboard Support | mATX / Mini-ITX | |
| Maximum VGA Length | 330mm | |
| Maximum CPU Cooler Height | 165mm | |
| Maximum PSU Length | 180mm | |
| PCI Expansion Slots | 4 | |
| Drive Bays | 2 x 3.5” / 4 x 2.5” | |
|
Fan Support |
Top | 2 x 120mm |
| Front | 3 x 120mm | |
| Rear | 1 x 120mm | |
| Bottom | 2 x 120mm | |
| Pre-Installed Fan(s) | Front | 1 x 120mm |
| Rear | 1 x 120mm(with White LED Effect) | |
| Radiator Support | Top | 240mm |
| Side | 240mm | |
| I/O Ports | 1 x Headphone Jack, 1 x Microphone Jack,
1 x USB3.0, 2 x USB2.0, Power Button, Reset Button |
|
Accessories
I/O Ports
| # | Part | # | Part | # | Part | # | Part |
| ⓐ | USB 2.0 Ports | ⓑ | USB 3.0 Port | ⓒ | Microphone Jack | ⓓ | HDD / Power LED |
| ⓔ | Headphone Jack | ⓕ | Reset Button | ⓖ | Power Button | ⓗ |
Mounting the fans
I/O Connectors
Documents / Resources
 |
ZALMAN M3 Matx Mini Tower Computer Case [pdf] User Manual M3, Matx Mini Tower Computer Case, Mini Tower Computer Case, Tower Computer Case, M3, Computer Case |
 |
ZALMAN M3 mATX Mini Tower Computer Case [pdf] User Manual M3 mATX Mini Tower Computer Case, M3, mATX Mini Tower Computer Case, Mini Tower Computer Case, Tower Computer Case, Case, Computer Case |
