It is suitable for: All TOTOLINK routers
Application introduction:
This article describes how to quickly make a wireless connection through the router’s WPS button.
Diagram
Set up steps
STEP-1:
* Please make sure your router has WPS button before setting.
* Please make sure your wireless client supports WPS functionality before setting.
STEP-2:
Press WPS button on the router for 1s, WPS enabled. There are two types of wireless router WPS buttons: RST/WPS button and WPS button. As shown below.
2-1. RST/WPS button：
2-2. WPS button：
Note: If router is a RST/WPS button, no more than 5s, router will be reset to factory defaults if you press it for more than 5s.
STEP-3:
After pressing the WPS button, use wireless client to connect to the router WIFI signal. Using Computer and Mobile phone wireless connection as an example. As shown below.
3-1. Computer wireless connection:
3-2. Mobile phone wireless connection:
DOWNLOAD
How to use the router’s WPS button – [Download PDF]
