TOSHIBA Setting IP Address on A3
Models Supported
e-Bridge Next Series III |
Colour e-STUDIO 2020AC / 2525AC / 3025AC / 3525AC / 4525AC / 5525AC / 6525ACMono e-STUDIO 2528A / 5525A / 6528A |
e-Bridge Next Series II |
Colour e-STUDIO 2010AC / 2515AC / 3015AC / 3515AC / 4515AC / 5015AC / 5516AC / 6516AC / 7516AC Mono e-STUDIO 2518A / 5518A / 7518A / 8518A |
e-Bridge Next Series I |
Colour e-STUDIO 2000AC / 2505AC / 3005AC / 3505AC / 4505AC / 5005AC / 5506AC / 6506AC / 7506ACMono e-STUDIO 2508A / 3508A / 4508A 3508LP / 4508LP / 5508A / 7508A / 8508A |
Changing the Address on the MFD Front panel
- First go to the front panel of the copier, and press on User Functions –User- If you don’t see this on your main panel, you may have to go to the right, may be on screen 2.
- Then click on the Admin tab
- Next input your password of 123456 and press ok.
- Next press on the Network button
- Then choose IPv4 from the list
- Most commonly used are Static IP (hardcoded not depending on DHCP Server) or Dynamic (which will take an available address from your network router/server and assign the next available number). So here input your Static IP, dependent on a free IP address which is not being currently used. Or change to Dynamic, this will grey out your selections and choose the next available IP address.
- Once you have updated this section, press on Apply Now, and close
- Wait for the printer to come back to the main screen at ready. Repeat the process to get into the IPv4 area and check to ensure either
- It has retained the static IP address you inputted
- It has taken an available DHCP address from our Server or Router
Next Section covers how to updated IP details via TopAccess (copier Web Browser Interface) Setting IP details via TopAccess
- Open a web browser window on your PC / MacIntosh, input your printers IP address into the URL field(uniform resource location). Then click on Login on the right hand side of the page
- Next input your user name and password, admin as user, 123456 as the password
- Next click on Administration and then Network
- Then scroll down to IPv4, here you have much of the same selections with regards to IPv4. Here set as either Static or Dynamic
- Next scroll back to the top of the screen and click on save
- Here you click on OK, this will update any changes you have put into effect
Documents / Resources
![]() | TOSHIBA Setting IP Address on A3 [pdf] Instructions Setting IP Address on A3, IP Address on A3, Setting Address on A3, Address on A3 |