Installation
The shape of mounting plate is optional on demands.
DIMENSIONS
Adjusting infrared detection range
Turn RIGHT: Longer / Turn LEFT: ShorterTurn
Installation
- Remove the black ABA Screw Nut from Button
- Install Button to the selected mounting plate.
- Adjust detection range of infrared sensor
- Use a screwdriver to screw the mounting plate on the wall.
Model:
AR-101-PBI-L Touch-less Infrared Sensor Push Button (Anti-Interference)
- a.DMET-101PJ01 (Stainless steel plate)
- b.DMET-101PJ05 (Stainless steel plate)
- c.DMET-101PJ03 (Stainless steel plate)
- d.AR-PB-6A ( plastic panel)
- e.AR-PB-7A ( plastic panel)
- f.AR-PB-8A ( plastic panel)
Connector Table
- When POWER is not wired, AR-101-PBI-L become powerless, it can still open door by hard press it.
- When powering on, the sensing area could not be shielded to avoid affecting the sensing distance.
Controller has built-in resistor and connected to +5VDC, external power supply current must be exceeding 20mA
Wiring Diagram
The Wiring Diagram of LED R/G Door Status Indication
Documents / Resources
 | SOYAL R-101-PBI-L Touch-Less Infrared Sensor Push Button [pdf] Instruction Manual R-101-PBI-L Touch-Less Infrared Sensor Push Button, R-101-PBI-L, Touch-Less Infrared Sensor Push Button, Infrared Sensor Push Button, Sensor Push Button, Push Button, Button |
