n-com SPCOM00000022 B4 KeyPad Control Panel
INSTRUCTIONS FOR REPLACING THE SPCOM00000022
- Remove the N-Com system from the helmet (see instruction booklet).
- Remove the keypad (Fig. 1).
- If necessary, before you apply the new keypad, remove the bi-adhesive found on the plastic coupling clip.
- Apply the new keypad (Fig. 2-3).
- Reposition the N-Com system inside the helmet (see instruction booklet).
Documents / Resources
 |
n-com SPCOM00000022 B4 KeyPad Control Panel [pdf] Instruction Manual SPCOM00000022 B4 KeyPad Control Panel, SPCOM00000022, B4 KeyPad Control Panel, KeyPad Control Panel, B4 Control Panel, Control Panel |
