MASTERBUILT MB20070924 Power Circuit Board
Specifications
- Product Name: Power Circuit Board (PCB)
- Model Numbers: MB20070924, MB20072024, MB20072124, MB20072224
- Tool Required: Phillips head screwdriver
Product Usage Instructions
Access/Replacement Steps for MB20070924:
CAUTION
- Always remove plug from the outlet before servicing your smoker.
- Make sure your smoker has fully cooled to avoid burns.
- Some components may have sharp edges. Use caution to avoid injury.
Tool needed for access and replacement: Phillips head screwdriver.
- Remove 6 screws and PCB shields. The shield is located on the bottom of the smoker.
- Remove the zip tie.
- Unplug all 6 wires from connection terminals and remove 4 screws.
- Remove the PCB with the plastic housing.
- Replace with the new PCB:
- The White Sleeve and Yellow wire go through the right hole.
- The Blue, Red, Black, and White wires go through the left hole.
- Plug in the large white sleeved terminal connection. Secure the PCB board with 4 screws.
- Plug in the Yellow ground wire.
- Plug in the Blue and White terminal connections.
- Plug in the Black terminal connection.
- Plug in the Red terminal connection.
- Zip-tie the wires.
- Replace the plastic shield.
Frequently Asked Questions (FAQ)
Q: What tools are needed for accessing or replacing the Power Circuit Board (PCB)?
A: A Phillips head screwdriver is required for accessing or replacing the PCB.
Documents / Resources
 | MASTERBUILT MB20070924 Power Circuit Board [pdf] Installation Guide MB20070924, MB20072024, MB20072124, MB20072224, MB20070924 Power Circuit Board, MB20070924, Power Circuit Board, Circuit Board, Board |
