KOLINK Unity Nexus ARGB Midi Tower Case User Manual

Left Panel – Unscrew the two thumbscrews and slide the glass panel backwards.
Right Panel – Unscrew the two thumbscrews and slide off.
Front Panel – Find the bottom cut out, stabilise the chassis with one hand, and pull from the cutout with a little force until the clips release.

3. MOTHERBOARD INSTALLATION

Align your motherboard with the chassis to locate where the stand-offs should be installed.
Once done, remove the motherboard and fasten stand-offs accordingly.
Insert your motherboard I/O plate into the cutout at the rear of the case.
Place your motherboard into the chassis, making sure the rear ports fit into the I/O plate.
Use the provided motherboard screws to attach your motherboard to the chassis.

4. POWER SUPPLY INSTALLATION

Place PSU in the bottom rear of the case, within the PSU shroud.
Align the holes and secure with screws.

5. GRAPHICS CARD/PCI-E CARD INSTALLATION

VIDEO CARD/PCI-E CARD INSTALLATION

Remove the rear PCI-E slot covers as necessary (depending on the slot size of your card)
Carefully position and slide your PCI-E card into place,
then secure with the add-on card screws supplied.
If mounting vertically, attach the provided vertical GPU bracket to the PSU shroud, secure
your Kolink PCI-E riser cable to it (sold separately) and attach the cable to the motherboard.

Remove the rear PCI-E slot covers as necessary, then carefully position your PCI-E card, slot into the PCI-E riser mount and secure with the add-on screws supplied.

6. 2.5″ SDD INSTALLATION (R)

• Remove the bracket from the rear of the motherboard plate, attach your 2.5″ drive and then screw back into place.

7. 2.5″ SDD INSTALLATION (R)

Place the 2.5″ HDD/SSD into/on top of the HDD bracket and screw in if required.

8. 3.5″ HDD INSTALLATION

Place the 3.5″ HDD into/on top of the HDD bracket and screw in if required.

9. TOP FAN INSTALLATION

Remove the dust filter from the top of the case.
Align your fan(s) to the screw holes on the top of the chassis and secure with screws.
Replace your dust filter once secured.

10. FRONT/REAR FAN INSTALLATION

• Align your fan to the screw holes on the chassis and secure with screws.

11. WATERCOOLING RADIATOR INSTALLATION

12. I/O PANEL INSTALLATION

Carefully check the labelling of each connector from the I/O panel to identify their function.
Cross reference with the motherboard manual to locate where each wire should be installed,
then secure one at a time. Please ensure they are installed in the correct polarity to avoid non-function or damage.

Read More About This Manual & Download PDF:

Documents / Resources

KOLINK Unity Nexus ARGB Midi Tower Case [pdf] User Manual
Unity Nexus ARGB Midi Tower Case, Unity Nexus, ARGB Midi Tower Case

References

User Manual