RC250 5-Key Zigbee Wireless Smart Remote Control
Instructions
RC250 5-Key Zigbee Wireless Smart Remote Control
Connect your Innr Remote Control to Philips Hue
Step 1: Connect the Remote Control to the Philips Hue Bridge
Open the Philps Hue app and start searching for lights.
Remove the plastic tab to put the Remote Control in pairing mode. The LED on the front will start blinking once per second.*
The LED will rapidly blink twice to confirm it’s successfully connected.
NOTE: the Remote Control will not appear in the Philips Hue app.
*No blinking LED? Press and hold the reset button behind the battery lid for 3 seconds.
Step 2: Connect the Remote Control to the individual lights
Turn the light off for at least 5 seconds using the wall switch and turn it on again. The light is in pairing mode for 1 minute from now.Press the button in the middle together with the top button (big sun) and hold for 3 seconds. The LED will start blinking once per second.
Bring the Remote Control close to the light (< 10cm). The light will blink to confirm it’s successfully connected.
Repeat Step 2 for all lights that you want to connect to the Remote Control
Successful!
You can now control the connected light(s) from the app and with Remote Control.
Documents / Resources
 | innr RC250 5-Key Zigbee Wireless Smart Remote Control [pdf] Instructions RC250, 5-Key Zigbee Wireless Smart Remote Control, RC250 5-Key Zigbee Wireless Smart Remote Control |
 | innr RC250 5-Key Zigbee Wireless Smart Remote Control [pdf] User Manual RC250, 5-Key Zigbee Wireless Smart Remote Control, RC250 5-Key Zigbee Wireless Smart Remote Control, Zigbee Wireless Smart Remote Control, Wireless Smart Remote Control, Smart Remote Control, Remote Control |
