User manual
Supplementary information
DT3CS WIFI+BT Module
a) Trace layout and dimensions including specific designs for each type:
- Layout of trace design, parts, antenna, connectors, and isolation requirements:
Boundary limits of size, thickness, length, width, shape(s), dielectric contain, and impedance must be clearly described for each type of antenna: PCB Antenna trace antenna Dimension:
Note:
- RF trace between module RF pinout to antenna width is 0.292mm.
- RF trace between module and antenna impedance is 50ohm.
IPEX connector information:
Size:
| Connector 1 | I IPEX | Male pin | 500 | I Surface mount | varies |
b) Appropriate parts of manufacturers and specifications:
Information about devices on RF lines:
| Parts list | Parts number | Size | Manufacturer |
| Tuning 1/00 | / | 0201 | varies |
If customers completely refer to our antenna design for their own design, the antenna performance should also be the same as ours.
C) Test procedures and design verifications:
d) Production test procedures for ensuring compliance
Documents / Resources
 | ELECBEE DT3CS WIFI+BT Module [pdf] User Manual DT3CS WIFI BT Module, DT3CS, WIFI BT Module, Module |