Danfoss EKA 206 Adapter
Identification
RS485 Adapter, type EKA 206 and cable clip. Code no. 084B4088
Dimensions (units are in mm)
Installation
- Connect cable to controller
- Place the cable clip in guide slots
- Mount the cable clip – press down on arms
- Fix the RS-485 adapter\
- Connect cable to adapter
- Wire Modbus
- LED indicators during operation
Warning
- The installation of adapter must be performed while the controller is switched off.
- Ensure the Adapter is installed away from heating source, direct sunlight, dripping water, dusty environment.
- Do not mount the adapter in food compartment in case of cold space installation.
- Interface cable for connecting adapter to controller must be ordered separately.
- Ensure that cables are always strain relieved and tied up by other means to cabinet.
- It is important that the installation of the Modbus data communication cable is performed correctly with sufficient distance to high voltage cables.
Technical data
| Specification | Description | |
| Input voltage | 5 V DC from controller | |
| Current consumption | 20 mA | |
| IP rating | 20 | |
| Operating temperature | -10 – 55 °C (14 – 131 °F), 90% RH | |
| Storage temperature | -40 – 70 °C (-40 – 158 °F), 90% RH | |
| Supported controllers | EKC 223, EKC 224 | |
| Approvals1) | — | |
| Ordering | Interface cable | 080N0327 |
| EKA 206 RS485 adapter | 084B4088 (single pack), 084B4188 (I pack) | |
1) For latest approval status and other approvals, please check at Danfoss.com or contact your local Danfoss representative.
Documents / Resources
 | Danfoss EKA 206 Adapter [pdf] Installation Guide EKA 206, EKA 206 Adapter, Adapter |
