CNC4PC C34G214V Function Boards User Manual
OVERVIEW
This board interface is used for the connection between C35S, C62, C76, C82, M16D, C86MASSO, C86ACORN and GECKO DRIVE GR214.
FEATURES
- RJ45 Driver Input Connector
- Select Jumper for Hard Enable or Soft Enable.
- Alarm terminal
BOARD DESCRIPTION
JUMPER TO SELECT THE ENABLE
Use Software Enable to keep the driver active only while the system is active.
Set of jumpers as shown in the image.
SOFT ENABLE
Use Hardware Enable to keep the driver enabled all the time.
Set of jumpers as shown in the image.
HARD ENABLE
DRIVER RESET
When LOW, this input will reset the driver (phase outputs will disable).
WIRING SAMPLE
PINOUT
C34GR214 CONNECTOR RJ45 | |
| RJ45 Pins | Function |
| 1 | NOT USED |
| 2 | PUL+ |
| 3 | NOT USED |
| 4 | GND |
| 5 | ERR |
| 6 | DIR+ |
| 7 | NOT USED |
| 8 (5V) | EN+ |
DIMENSION
All dimensions are in Millimeters.
DISCLAIMER
Use caution. CNC machines can be dangerous machines.
Neither DUNCAN USA, LLC nor Arturo Duncan is liable for any accidents resulting from the improper use of these devices.
This product is not a fail-safe device and it should not be used in life support systems or in other devices where its failure or possible erratic operation could cause Board Description property damage, bodily injury or loss of life.
Documents / Resources
 | CNC4PC C34G214V Function Boards [pdf] User Manual C34G214V Function Boards, C34G214V, Function Boards, Boards |
